pw_sys_io_arduino/sys_io_arduino.cc

// Copyright 2019 The Pigweed Authors
//
// Licensed under the Apache License, Version 2.0 (the "License"); you may not
// use this file except in compliance with the License. You may obtain a copy of
// the License at
//
//     https://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
// WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
// License for the specific language governing permissions and limitations under
// the License.

#include <Arduino.h>

#include <cinttypes>
#include <cstdint>

#include "pw_preprocessor/compiler.h"
#include "pw_sys_io/sys_io.h"

extern "C" void pw_sys_io_Init() {
  Serial.begin(115200);
  // Wait for serial port to be available
  while (!Serial) {
  }
}

namespace pw::sys_io {

// Wait for a byte to read on USART1. This blocks until a byte is read. This is
// extremely inefficient as it requires the target to burn CPU cycles polling to
// see if a byte is ready yet.

Status ReadByte(std::byte* dest) {
  while (true) {
    if (Serial.available()) {
      *dest = static_cast<std::byte>(Serial.read());
      break;
    }
  }
  return Status::Ok();
}

// Send a byte over USART1. Since this blocks on every byte, it's rather
// inefficient. At the default baud rate of 115200, one byte blocks the CPU for
// ~87 micro seconds. This means it takes only 10 bytes to block the CPU for
// 1ms!
Status WriteByte(std::byte b) {
  // Wait for TX buffer to be empty. When the buffer is empty, we can write
  // a value to be dumped out of UART.
  while (Serial.availableForWrite() < 1) {
  }
  Serial.write((uint8_t)b);
  return Status::Ok();
}

// Writes a string using pw::sys_io, and add newline characters at the end.
StatusWithSize WriteLine(const std::string_view& s) {
  size_t chars_written = 0;
  StatusWithSize result = WriteBytes(std::as_bytes(std::span(s)));
  if (!result.ok()) {
    return result;
  }
  chars_written += result.size();

  // Write trailing newline.
  result = WriteBytes(std::as_bytes(std::span("\r\n", 2)));
  chars_written += result.size();

  return StatusWithSize(result.status(), chars_written);
}

}  // namespace pw::sys_io