/*
 * Copyright 2018 NXP
 * All rights reserved.
 *
 *
 * SPDX-License-Identifier: BSD-3-Clause
 */

#ifndef __SERIAL_PORT_UART_H__
#define __SERIAL_PORT_UART_H__

/*!
 * @addtogroup serial_port_uart
 * @{
 */

/*******************************************************************************
 * Definitions
 ******************************************************************************/
/*! @brief serial port uart handle size*/
#if (defined(SERIAL_MANAGER_NON_BLOCKING_MODE) && (SERIAL_MANAGER_NON_BLOCKING_MODE > 0U))
#define SERIAL_PORT_UART_HANDLE_SIZE (166U)
#else
#define SERIAL_PORT_UART_HANDLE_SIZE (4U)
#endif

/*! @brief serial port uart parity mode*/
typedef enum _serial_port_uart_parity_mode
{
    kSerialManager_UartParityDisabled = 0x0U, /*!< Parity disabled */
    kSerialManager_UartParityEven     = 0x1U, /*!< Parity even enabled */
    kSerialManager_UartParityOdd      = 0x2U, /*!< Parity odd enabled */
} serial_port_uart_parity_mode_t;

/*! @brief serial port uart stop bit count*/
typedef enum _serial_port_uart_stop_bit_count
{
    kSerialManager_UartOneStopBit = 0U, /*!< One stop bit */
    kSerialManager_UartTwoStopBit = 1U, /*!< Two stop bits */
} serial_port_uart_stop_bit_count_t;

/*! @brief serial port uart config struct*/
typedef struct _serial_port_uart_config
{
    uint32_t clockRate;                             /*!< clock rate  */
    uint32_t baudRate;                              /*!< baud rate  */
    serial_port_uart_parity_mode_t parityMode;      /*!< Parity mode, disabled (default), even, odd */
    serial_port_uart_stop_bit_count_t stopBitCount; /*!< Number of stop bits, 1 stop bit (default) or 2 stop bits  */
    uint8_t instance;                               /*!< Instance (0 - UART0, 1 - UART1, ...), detail information
                                                         please refer to the SOC corresponding RM. */
    uint8_t enableRx;                               /*!< Enable RX */
    uint8_t enableTx;                               /*!< Enable TX */
} serial_port_uart_config_t;
/*! @} */
#endif /* __SERIAL_PORT_UART_H__ */