/* ----------------------------------------------------------------------------
 *         ATMEL Microcontroller Software Support 
 * ----------------------------------------------------------------------------
 * Copyright (c) 2008, Atmel Corporation
 *
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions are met:
 *
 * - Redistributions of source code must retain the above copyright notice,
 * this list of conditions and the disclaimer below.
 *
 * Atmel's name may not be used to endorse or promote products derived from
 * this software without specific prior written permission.
 *
 * DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR
 * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
 * MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE
 * DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT,
 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
 * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA,
 * OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF
 * LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
 * NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,
 * EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 * ----------------------------------------------------------------------------
 */

/*
    Title: LED

    About: Purpose
        Small set of functions for simple and portable LED usage.

    About: Usage
        1 - Configure one or more LEDs using <LED_Configure> and
            <LED_ConfigureAll>.
        2 - Set, clear and toggle LEDs using <LED_Set>, <LED_Clear> and
            <LED_Toggle>.
        3 - Get the current status of a LED using <LED_Get>.

        LEDs are numbered starting from 0; the number of LEDs depend on the
        board being used. All the functions defined here will compile properly
        regardless of whether the LED is defined or not; they will simply
        return 0 when a LED which does not exist is given as an argument.
        Also, these functions take into account how each LED is connected on to
        board; thus, <LED_Set> might change the level on the corresponding pin
        to 0 or 1, but it will always light the LED on; same thing for the other
        methods.
*/

#ifndef LED_H
#define LED_H

//------------------------------------------------------------------------------
//         Exported functions
//------------------------------------------------------------------------------

extern unsigned char LED_Configure(unsigned int led);
extern unsigned char LED_Set(unsigned int led);
extern unsigned char LED_Clear(unsigned int led);
extern unsigned char LED_Toggle(unsigned int led);

#endif //#ifndef LED_H