/*********************************************************************************************************************** | |
* DISCLAIMER | |
* This software is supplied by Renesas Electronics Corporation and is only intended for use with Renesas products. | |
* No other uses are authorized. This software is owned by Renesas Electronics Corporation and is protected under all | |
* applicable laws, including copyright laws. | |
* THIS SOFTWARE IS PROVIDED "AS IS" AND RENESAS MAKES NO WARRANTIESREGARDING THIS SOFTWARE, WHETHER EXPRESS, IMPLIED | |
* OR STATUTORY, INCLUDING BUT NOT LIMITED TO WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND | |
* NON-INFRINGEMENT. ALL SUCH WARRANTIES ARE EXPRESSLY DISCLAIMED.TO THE MAXIMUM EXTENT PERMITTED NOT PROHIBITED BY | |
* LAW, NEITHER RENESAS ELECTRONICS CORPORATION NOR ANY OF ITS AFFILIATED COMPANIES SHALL BE LIABLE FOR ANY DIRECT, | |
* INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR ANY REASON RELATED TO THIS SOFTWARE, EVEN IF RENESAS OR | |
* ITS AFFILIATES HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. | |
* Renesas reserves the right, without notice, to make changes to this software and to discontinue the availability | |
* of this software. By using this software, you agree to the additional terms and conditions found by accessing the | |
* following link: | |
* http://www.renesas.com/disclaimer | |
* | |
* Copyright (C) 2015 Renesas Electronics Corporation. All rights reserved. | |
***********************************************************************************************************************/ | |
/*********************************************************************************************************************** | |
* File Name : r_cg_port.h | |
* Version : Code Generator for RZ/T1 V1.00.00.09 [02 Mar 2015] | |
* Device(s) : R7S910018CBG | |
* Tool-Chain : GCCARM | |
* Description : This file implements device driver for Port module. | |
* Creation Date: 22/04/2015 | |
***********************************************************************************************************************/ | |
#ifndef PORT_H | |
#define PORT_H | |
/*********************************************************************************************************************** | |
Macro definitions (Register bit) | |
***********************************************************************************************************************/ | |
/* | |
Port Direction Register (PDR) | |
*/ | |
/* Pmn Direction Control (B0 - B15) */ | |
#define _Pm0_MODE_NOT_USED (0x0000U) /* Pm0 not used (Hi-z input protection) */ | |
#define _Pm0_MODE_INPUT (0x0002U) /* Pm0 as input */ | |
#define _Pm0_MODE_OUTPUT (0x0003U) /* Pm0 as output */ | |
#define _Pm1_MODE_NOT_USED (0x0000U) /* Pm1 not used (Hi-z input protection) */ | |
#define _Pm1_MODE_INPUT (0x0008U) /* Pm1 as input */ | |
#define _Pm1_MODE_OUTPUT (0x000CU) /* Pm1 as output */ | |
#define _Pm2_MODE_NOT_USED (0x0000U) /* Pm2 not used (Hi-z input protection) */ | |
#define _Pm2_MODE_INPUT (0x0020U) /* Pm2 as input */ | |
#define _Pm2_MODE_OUTPUT (0x0030U) /* Pm2 as output */ | |
#define _Pm3_MODE_NOT_USED (0x0000U) /* Pm3 not used (Hi-z input protection) */ | |
#define _Pm3_MODE_INPUT (0x0080U) /* Pm3 as input */ | |
#define _Pm3_MODE_OUTPUT (0x00C0U) /* Pm3 as output */ | |
#define _Pm4_MODE_NOT_USED (0x0000U) /* Pm4 not used (Hi-z input protection) */ | |
#define _Pm4_MODE_INPUT (0x0200U) /* Pm4 as input */ | |
#define _Pm4_MODE_OUTPUT (0x0300U) /* Pm4 as output */ | |
#define _Pm5_MODE_NOT_USED (0x0000U) /* Pm5 not used (Hi-z input protection) */ | |
#define _Pm5_MODE_INPUT (0x0800U) /* Pm5 as input */ | |
#define _Pm5_MODE_OUTPUT (0x0C00U) /* Pm5 as output */ | |
#define _Pm6_MODE_NOT_USED (0x0000U) /* Pm6 not used (Hi-z input protection) */ | |
#define _Pm6_MODE_INPUT (0x2000U) /* Pm6 as input */ | |
#define _Pm6_MODE_OUTPUT (0x3000U) /* Pm6 as output */ | |
#define _Pm7_MODE_NOT_USED (0x0000U) /* Pm7 not used (Hi-z input protection) */ | |
#define _Pm7_MODE_INPUT (0x8000U) /* Pm7 as input */ | |
#define _Pm7_MODE_OUTPUT (0xC000U) /* Pm7 as output */ | |
/* | |
Port Output Data Register (PODR) | |
*/ | |
/* Pmn Output Data Store (B0 - B7) */ | |
#define _Pm0_OUTPUT_0 (0x00U) /* Output low at B0 */ | |
#define _Pm0_OUTPUT_1 (0x01U) /* Output high at B0 */ | |
#define _Pm1_OUTPUT_0 (0x00U) /* Output low at B1 */ | |
#define _Pm1_OUTPUT_1 (0x02U) /* Output high at B1 */ | |
#define _Pm2_OUTPUT_0 (0x00U) /* Output low at B2 */ | |
#define _Pm2_OUTPUT_1 (0x04U) /* Output high at B2 */ | |
#define _Pm3_OUTPUT_0 (0x00U) /* Output low at B3 */ | |
#define _Pm3_OUTPUT_1 (0x08U) /* Output high at B3 */ | |
#define _Pm4_OUTPUT_0 (0x00U) /* Output low at B4 */ | |
#define _Pm4_OUTPUT_1 (0x10U) /* Output high at B4 */ | |
#define _Pm5_OUTPUT_0 (0x00U) /* Output low at B5 */ | |
#define _Pm5_OUTPUT_1 (0x20U) /* Output high at B5 */ | |
#define _Pm6_OUTPUT_0 (0x00U) /* Output low at B6 */ | |
#define _Pm6_OUTPUT_1 (0x40U) /* Output high at B6 */ | |
#define _Pm7_OUTPUT_0 (0x00U) /* Output low at B7 */ | |
#define _Pm7_OUTPUT_1 (0x80U) /* Output high at B7 */ | |
/* | |
Pull-Up/Pull-Down Control Register (PCR) | |
*/ | |
/* Pmn Input Pull-Up Resistor Control (B0 - B15) */ | |
#define _Pm0_PULLUPDOWN_DISABLE (0x0000U) /* Pm0 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm0_PULLUPDOWN_PULLDOWN_ON (0x0001U) /* Pm0 pull-down resistor connected */ | |
#define _Pm0_PULLUPDOWN_PULLUP_ON (0x0002U) /* Pm0 pull-up resistor connected */ | |
#define _Pm1_PULLUPDOWN_DISABLE (0x0000U) /* Pm1 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm1_PULLUPDOWN_PULLDOWN_ON (0x0004U) /* Pm1 pull-down resistor connected */ | |
#define _Pm1_PULLUPDOWN_PULLUP_ON (0x0008U) /* Pm1 pull-up resistor connected */ | |
#define _Pm2_PULLUPDOWN_DISABLE (0x0000U) /* Pm2 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm2_PULLUPDOWN_PULLDOWN_ON (0x0010U) /* Pm2 pull-down resistor connected */ | |
#define _Pm2_PULLUPDOWN_PULLUP_ON (0x0020U) /* Pm2 pull-up resistor connected */ | |
#define _Pm3_PULLUPDOWN_DISABLE (0x0000U) /* Pm3 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm3_PULLUPDOWN_PULLDOWN_ON (0x0040U) /* Pm3 pull-down resistor connected */ | |
#define _Pm3_PULLUPDOWN_PULLUP_ON (0x0080U) /* Pm3 pull-up resistor connected */ | |
#define _Pm4_PULLUPDOWN_DISABLE (0x0000U) /* Pm4 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm4_PULLUPDOWN_PULLDOWN_ON (0x0100U) /* Pm4 pull-down resistor connected */ | |
#define _Pm4_PULLUPDOWN_PULLUP_ON (0x0200U) /* Pm4 pull-up resistor connected */ | |
#define _Pm5_PULLUPDOWN_DISABLE (0x0000U) /* Pm5 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm5_PULLUPDOWN_PULLDOWN_ON (0x0400U) /* Pm5 pull-down resistor connected */ | |
#define _Pm5_PULLUPDOWN_PULLUP_ON (0x0800U) /* Pm5 pull-up resistor connected */ | |
#define _Pm6_PULLUPDOWN_DISABLE (0x0000U) /* Pm6 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm6_PULLUPDOWN_PULLDOWN_ON (0x1000U) /* Pm6 pull-down resistor connected */ | |
#define _Pm6_PULLUPDOWN_PULLUP_ON (0x2000U) /* Pm6 pull-up resistor connected */ | |
#define _Pm7_PULLUPDOWN_DISABLE (0x0000U) /* Pm7 pull-up resistor and pull-down resistor not connected */ | |
#define _Pm7_PULLUPDOWN_PULLDOWN_ON (0x4000U) /* Pm7 pull-down resistor connected */ | |
#define _Pm7_PULLUPDOWN_PULLUP_ON (0x8000U) /* Pm7 pull-up resistor connected */ | |
/* | |
Drive Capacity Control Register (DSCR) | |
*/ | |
/* P10 Drive Capacity Control (B0) */ | |
#define _Pm0_HIDRV_OFF (0x0000U) /* P10 Normal drive output */ | |
#define _Pm0_HIDRV_ON (0x0001U) /* P10 High-drive output */ | |
/*********************************************************************************************************************** | |
Macro definitions | |
***********************************************************************************************************************/ | |
/*********************************************************************************************************************** | |
Typedef definitions | |
***********************************************************************************************************************/ | |
/*********************************************************************************************************************** | |
Global functions | |
***********************************************************************************************************************/ | |
void R_PORT_Create(void); | |
/* Start user code for function. Do not edit comment generated here */ | |
/* End user code. Do not edit comment generated here */ | |
#endif |