| /** ################################################################### | |
| ** THIS BEAN MODULE IS GENERATED BY THE TOOL. DO NOT MODIFY IT. | |
| ** Filename : PE_Error.H | |
| ** Project : RTOSDemo | |
| ** Processor : MC9S12DP256BCPV | |
| ** Beantype : PE_Error | |
| ** Version : Driver 01.00 | |
| ** Compiler : Metrowerks HC12 C Compiler | |
| ** Date/Time : 13/06/2005, 20:14 | |
| ** Abstract : | |
| ** This bean "PE_Error" contains internal definitions | |
| ** of the error constants. | |
| ** Settings : | |
| ** Contents : | |
| ** No public methods | |
| ** | |
| ** (c) Copyright UNIS, spol. s r.o. 1997-2002 | |
| ** UNIS, spol. s r.o. | |
| ** Jundrovska 33 | |
| ** 624 00 Brno | |
| ** Czech Republic | |
| ** http : www.processorexpert.com | |
| ** mail : info@processorexpert.com | |
| ** ###################################################################*/ | |
| #ifndef __PE_Error_H | |
| #define __PE_Error_H | |
| #define ERR_OK 0 /* OK */ | |
| #define ERR_SPEED 1 /* This device does not work in the active speed mode. */ | |
| #define ERR_RANGE 2 /* Parameter out of range. */ | |
| #define ERR_VALUE 3 /* Parameter of incorrect value. */ | |
| #define ERR_OVERFLOW 4 /* Timer overflow. */ | |
| #define ERR_MATH 5 /* Overflow during evaluation. */ | |
| #define ERR_ENABLED 6 /* Device is enabled. */ | |
| #define ERR_DISABLED 7 /* Device is disabled. */ | |
| #define ERR_BUSY 8 /* Device is busy. */ | |
| #define ERR_NOTAVAIL 9 /* Requested value or method not available. */ | |
| #define ERR_RXEMPTY 10 /* No data in receiver. */ | |
| #define ERR_TXFULL 11 /* Transmitter is full. */ | |
| #define ERR_BUSOFF 12 /* Bus not available. */ | |
| #define ERR_OVERRUN 13 /* Overrun error is detected. */ | |
| #define ERR_FRAMING 14 /* Framing error is detected. */ | |
| #define ERR_PARITY 15 /* Parity error is detected. */ | |
| #define ERR_NOISE 16 /* Noise error is detected. */ | |
| #define ERR_IDLE 17 /* Idle error is detectes. */ | |
| #define ERR_FAULT 18 /* Fault error is detected. */ | |
| #define ERR_BREAK 19 /* Break char is received during communication. */ | |
| #define ERR_CRC 20 /* CRC error is detected. */ | |
| #define ERR_ARBITR 21 /* A node losts arbitration. This error occurs if two nodes start transmission at the same time. */ | |
| #define ERR_PROTECT 22 /* Protection error is detected. */ | |
| #endif //__PE_Error_H |