| ============================================================================= | |
| List of methods in project: RTOSDemo | |
| THIS TEXT DESCRIPTION IS GENERATED BY THE TOOL. DO NOT MODIFY IT. | |
| ============================================================================= | |
| Module "TickTimer" (bean TimerInt) | |
| TickTimer_Enable -Enable the bean - it starts the timer. Events may be generated ("DisableEvent"/"EnableEvent"). | |
| TickTimer_SetPeriodTicks16 -This method sets the new period of the generated events. The period is expressed in CPU [ticks] | |
| as a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is | |
| selected in the <Timing dialog box> in Runtime setting area. | |
| TickTimer_SetPeriodTicks32 -This method sets the new period of the generated events. The period is expressed in CPU [ticks] | |
| as a 32-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is | |
| selected in the <Timing dialog box> in Runtime setting area. | |
| TickTimer_SetPeriodUS -This method sets the new period of the generated events. The period is expressed in [microseconds] as | |
| a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is | |
| selected in the <Timing dialog box> in Runtime setting area. | |
| TickTimer_SetPeriodMS -This method sets the new period of the generated events. The period is expressed in [miliseconds] as | |
| a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is | |
| selected in the <Timing dialog box> in Runtime setting area. | |
| TickTimer_SetFreqHz -This method sets the new frequency of the generated events. The frequency is expressed in [Hz] as a | |
| 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is | |
| selected in the <Timing dialog box> in Runtime setting area. | |
| Module "Byte1" (bean ByteIO) | |
| Byte1_PutBit -Put the specified value to the specified bit/pin of the Input/Output bean. If direction is [input] saves the | |
| value to a memory or a register, this value will be written to the pin after switching to the output mode - | |
| using [SetDir(TRUE)]. If direction is [output] writes the value to the pin. | |
| Byte1_NegBit -Negate (invert) the specified bit of the Input/Output bean. It is the same as [PutBit(Bit,!GetBit(Bit))]. | |
| Module "COM0" (bean AsynchroSerial) | |
| COM0_SetBaudRateMode -This method changes the channel communication speed (baud rate). This method can be used only if you | |
| specify a list of possible period settings at design time (see <Timing dialog box> - Runtime setting - from a | |
| list of values). Each of these settings constitutes a mode and Processor Expert^[TM] assigns them a mode | |
| identifier. The prescaler and compare values corresponding to each mode are calculated at design time. You may | |
| switch modes at runtime by referring only to a mode identifier. No run-time calculations are performed, all the | |
| calculations are performed at design time. | |
| Module "Cpu" (bean MC9S12DP256_112) | |
| Cpu_EnableInt -Enable maskable interrupts | |
| Cpu_DisableInt -Disable maskable interrupts | |
| ============================================================================= |