Pigweed kernel target for the AST10x0 platform.
Build all targets under the AST10x0 tree with:
bazel build //target/ast10x0/...
Run the AST10x0 test targets with:
bazel test //target/ast10x0/...
This builds the AST10x0 test targets and any required dependencies. Firmware- backed tests are skipped unless a runner is configured.
Run the full AST10x0 test suite under QEMU with:
bazel test --config=virt_ast10x0 //target/ast10x0/...
The virt_ast10x0 config launches images under QEMU (ast1030-evb machine) using a local sentinel-based runner. Pass/fail is signalled by the firmware writing TEST_RESULT:PASS or TEST_RESULT:FAIL to UART. See target/ast10x0/tests/README.md for details.
For more detailed failures:
bazel test --config=virt_ast10x0 --verbose_failures //target/ast10x0/...
Run the AST10x0 tests on a physical AST1060 EVB attached to a Raspberry Pi test fixture with:
AST1060_EVB_PI_HOST=<user>@<pi-host> bazel test --config=k_ast1060_evb //target/ast10x0/tests/...
Key-based SSH auth to the Pi is required. See target/ast10x0/tests/README.md for the fixture details.
To check the hardware tests for flakiness, run each test multiple times with result caching disabled:
Using Pigweed workflow
AST1060_EVB_PI_HOST=<user>@<pi-host> ./pw flaky
Or directly with Bazel
AST1060_EVB_PI_HOST=<user>@<pi-host> bazel test \ --runs_per_test=2 \ --runs_per_test_detects_flakes \ --cache_test_results=no \ --keep_going \ --test_output=errors \ --config=k_ast1060_evb \ //target/ast10x0/tests/...
--runs_per_test=3 runs every test thrice (increase for a stricter check).--runs_per_test_detects_flakes reports a test that passes in some runs and fails in others as FLAKY instead of FAILED.--cache_test_results=no forces real runs on the board.--keep_going continues past failures so the whole suite is assessed.--test_output=errors prints the log of failing runs.bazel build //target/ast10x0/... builds all targets under the AST10x0 tree.bazel test //target/ast10x0/... builds the AST10x0 test targets and any required dependencies, but skips bare-metal test execution.bazel test --config=virt_ast10x0 //target/ast10x0/... executes the AST10x0 system-image tests under QEMU.