#
#    Copyright (c) 2022-2023 Project CHIP Authors
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#

# This sample uses sample-defaults.conf to set options common for all
# samples. This file should contain only options specific for this sample
# or overrides of default values.

# enable GPIO
CONFIG_GPIO=y

# enable PWM
CONFIG_PWM=y

# OpenThread configs
CONFIG_OPENTHREAD_MTD=y
CONFIG_OPENTHREAD_FTD=n
CONFIG_CHIP_ENABLE_SLEEPY_END_DEVICE_SUPPORT=n
CONFIG_CHIP_SED_IDLE_INTERVAL=200
CONFIG_CHIP_THREAD_SSED=n

# Default OpenThread network settings
CONFIG_OPENTHREAD_PANID=4660
CONFIG_OPENTHREAD_CHANNEL=15
CONFIG_OPENTHREAD_NETWORK_NAME="OpenThreadDemo"
CONFIG_OPENTHREAD_XPANID="11:11:11:11:22:22:22:22"

# Disable Matter OTA DFU
CONFIG_CHIP_OTA_REQUESTOR=n

# CHIP configuration
CONFIG_CHIP_PROJECT_CONFIG="include/CHIPProjectConfig.h"
CONFIG_CHIP_OPENTHREAD_CONFIG="../../platform/telink/project_include/OpenThreadConfig.h"

CONFIG_CHIP_DEVICE_VENDOR_ID=65521
# CHIP PID: 32769 == 0x8001 (all-clusters-app)
CONFIG_CHIP_DEVICE_PRODUCT_ID=32769
CONFIG_CHIP_DEVICE_TYPE=65535

CONFIG_CHIP_DEVICE_SOFTWARE_VERSION=1
CONFIG_CHIP_DEVICE_SOFTWARE_VERSION_STRING="2022"

# Enable CHIP pairing automatically on application start.
CONFIG_CHIP_ENABLE_PAIRING_AUTOSTART=y

# CHIP shell
CONFIG_CHIP_LIB_SHELL=n

# Disable factory data support. 
CONFIG_CHIP_FACTORY_DATA=n
CONFIG_CHIP_FACTORY_DATA_BUILD=n
CONFIG_CHIP_FACTORY_DATA_MERGE_WITH_FIRMWARE=n

# Enable Button IRQ mode. The poling mode is used by default.
CONFIG_CHIP_BUTTON_MANAGER_IRQ_MODE=n

# Disable Status LED.
CONFIG_CHIP_ENABLE_APPLICATION_STATUS_LED=y

# Enable Power Management
CONFIG_PM=n
CONFIG_PM_DEVICE=n