The Open IoT SDK Lock Example demonstrates how to remotely control a door lock a device with one basic bolt.
The example behaves as a Matter accessory, device that can be paired into an existing Matter network and can be controlled by it.
For information on how to build and run this example and further information about the platform it is run on see Open IoT SDK examples.
The example name to use in the scripts is lock-app.
Communication with the application goes through the active telnet session. When the application runs these lines should be visible:
[INF] [-] Open IoT SDK lock-app example application start ... [INF] [-] Open IoT SDK lock-app example application run
The lock-app application launched correctly and you can follow traces in the terminal.
Read the Open IoT SDK commissioning guide to see how to use the Matter controller to commission and control the application.
The application fully supports the DoorLock cluster. Use its commands to trigger actions on the device. You can issue commands through the same Matter controller you used to perform the commissioning step above.
Example command:
zcl DoorLock LockDoor 1234 1 pinCode=str:12345
In response the device will output this line to the terminal:
[INF] [ZC] Lock App: specified PIN code was found in the database, setting door lock state to "Locked" [endpointId=1]