#
#    Copyright (c) 2020 Project CHIP Authors
#    Copyright (c) 2018 Nest Labs, Inc.
#    All rights reserved.
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#
#    Description:
#      CI uses this to select the ESP32C3-DevKitM.
#
# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200

#enable BT
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y

#enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_FILENAME="partitions.csv"

#enable lwIP route hooks
CONFIG_LWIP_HOOK_IP6_ROUTE_DEFAULT=y
CONFIG_LWIP_HOOK_ND6_GET_GW_DEFAULT=y

# Serial Flasher config
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"

# PW RPC Debug channel
CONFIG_EXAMPLE_UART_PORT_NUM=0
CONFIG_EXAMPLE_UART_BAUD_RATE=115200
CONFIG_EXAMPLE_UART_RXD=3
CONFIG_EXAMPLE_UART_TXD=1
CONFIG_ENABLE_PW_RPC=y