CONFIG_IDF_TARGET="esp32h2"

# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_FLASHMODE_QIO=y
CONFIG_ESPTOOLPY_FLASHFREQ_40M=y
CONFIG_ESPTOOLPY_FLASHFREQ="40m"
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200

# libsodium
CONFIG_LIBSODIUM_USE_MBEDTLS_SHA=y


# NIMBLE
CONFIG_BT_ENABLED=y
CONFIG_BT_BLUEDROID_ENABLED=n
CONFIG_BT_NIMBLE_ENABLED=y
CONFIG_BT_NIMBLE_50_FEATURE_SUPPORT=y
CONFIG_BT_NIMBLE_EXT_ADV=n
CONFIG_BT_NIMBLE_USE_ESP_TIMER=n
CONFIG_BTDM_CTRL_MODE_BLE_ONLY=y
CONFIG_BTDM_CTRL_MODE_BR_EDR_ONLY=n
CONFIG_BTDM_CTRL_MODE_BTDM=n
CONFIG_DEINIT_BLE_ON_COMMISSIONING_COMPLETE=n

# Enable OpenThread
CONFIG_OPENTHREAD_ENABLED=y
CONFIG_OPENTHREAD_SRP_CLIENT=y

# Disable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=n

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions_h2.csv"

# LwIP config for OpenThread
CONFIG_LWIP_IPV6_NUM_ADDRESSES=8
CONFIG_LWIP_MULTICAST_PING=y

# mbedTLS
CONFIG_MBEDTLS_HARDWARE_AES=n
CONFIG_MBEDTLS_HARDWARE_MPI=n
CONFIG_MBEDTLS_HARDWARE_SHA=n
CONFIG_MBEDTLS_ATCA_HW_ECDSA_SIGN=n
CONFIG_MBEDTLS_ATCA_HW_ECDSA_VERIFY=n
CONFIG_MBEDTLS_CMAC_C=y
CONFIG_MBEDTLS_SSL_PROTO_DTLS=y
CONFIG_MBEDTLS_KEY_EXCHANGE_ECJPAKE=y

# MDNS platform
CONFIG_USE_MINIMAL_MDNS=n

# Increase stacks size
CONFIG_NIMBLE_CONTROLLER_TASK_STACK_SIZE=5120
CONFIG_NIMBLE_HOST_TASK_STACK_SIZE=5120

# ESP32H2 BLE using a ext 32k crystal
CONFIG_ESP32H2_RTC_CLK_SRC_EXT_CRYS=y
CONFIG_ESP32H2_RTC_CLK_CAL_CYCLES=576

# FreeRTOS should use legacy API
CONFIG_FREERTOS_ENABLE_BACKWARD_COMPATIBILITY=y

# Disable STA and AP for ESP32H2
CONFIG_ENABLE_WIFI_STATION=n
CONFIG_ENABLE_WIFI_AP=n

# Enable OTA Requestor
CONFIG_ENABLE_OTA_REQUESTOR=y