Matter Open IoT SDK OTA-Requestor-App Example Application

The Open IoT SDK OTA-Requestor Example demonstrates how to remotely trigger update image downloading and apply it if needed. It provides the service for Matter's OTA clusters. This application plays both roles: the server for the OTA Requestor cluster, and the client of the OTA Provider cluster. It can initiate a software update with a given OTA Provider node, download a binary file and apply it.

The application is configured to support:

The example behaves as a Matter accessory, device that can be paired into an existing Matter network and can be controlled by it.

Build-run-test-debug

For information on how to build, run, test and debug this example and further information about the platform it is run on see Open IoT SDK examples.

The example name to use in the scripts is ota-requestor-app.

Example output

When the example runs, these lines should be visible:

[INF] [-] Open IoT SDK ota-requestor-app example application start
...
[INF] [-] Open IoT SDK ota-requestor-app example application run

This means the ota-requestor-app application launched correctly and you can follow traces in the terminal.

Commissioning

Read the Open IoT SDK commissioning guide to see how to use the Matter controller to commission and control the application.

Device Firmware Upgrade

Read the Matter Open IoT SDK Example Device Firmware Upgrade to see how to use Matter OTA for firmware update.

OtaSoftwareUpdateRequestor cluster usage

The application fully supports the OTA Requestor cluster. Use its commands to trigger actions on the device. You can issue commands through the same Matter controller you used to perform the commissioning step above.

Example command:

chip-tool otasoftwareupdaterequestor announce-ota-provider 1234 0 2 0 4321 0

The OTA Requestor application with node ID 1234 will process this command and send a QueryImage command to the OTA Provider with node ID 4321. This starts the OTA process. On receiving the QueryImageResponse from the OTA Provider application, the OTA Requestor application will verify that the software version specified in the SoftwareVersion field of the response contains a value newer than the current running version. The available version will be printed to the terminal, for example:

[INF] [-] New version of the software is available: 2

If the validation does not pass the update will not proceed. The next step is downloading the update image. If this step is completed, a new image will be installed and the application will be reboot.

More details about device firmware update over Matter can be found here.