CONFIG_IDF_TARGET="esp32c6"

# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_FLASHMODE_QIO=y
CONFIG_ESPTOOLPY_FLASHFREQ_40M=y
CONFIG_ESPTOOLPY_FLASHFREQ="40m"
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200

# libsodium
CONFIG_LIBSODIUM_USE_MBEDTLS_SHA=y


# NIMBLE
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y
CONFIG_BT_NIMBLE_EXT_ADV=n
CONFIG_BT_NIMBLE_HCI_EVT_BUF_SIZE=70
CONFIG_USE_BLE_ONLY_FOR_COMMISSIONING=n

# Disable OpenThread
CONFIG_OPENTHREAD_ENABLED=n

# Disable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=n

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions.csv"

# LwIP config for OpenThread
CONFIG_LWIP_IPV6_NUM_ADDRESSES=8
CONFIG_LWIP_MULTICAST_PING=y

# mbedTLS
CONFIG_MBEDTLS_HARDWARE_AES=n
CONFIG_MBEDTLS_HARDWARE_MPI=n
CONFIG_MBEDTLS_HARDWARE_SHA=n
CONFIG_MBEDTLS_HARDWARE_ECC=y
CONFIG_MBEDTLS_CMAC_C=y
CONFIG_MBEDTLS_KEY_EXCHANGE_ECJPAKE=y
CONFIG_MBEDTLS_ECJPAKE_C=y

# MDNS platform
CONFIG_USE_MINIMAL_MDNS=y
CONFIG_ENABLE_EXTENDED_DISCOVERY=y

# FreeRTOS should use legacy API
CONFIG_FREERTOS_ENABLE_BACKWARD_COMPATIBILITY=y

# Wi-Fi Settings
CONFIG_ENABLE_WIFI_STATION=y
CONFIG_ENABLE_WIFI_AP=n
# Enable this to avoid implicit declaration of function 'esp_send_assoc_resp'
CONFIG_ESP_WIFI_SOFTAP_SUPPORT=y

# Enable OTA Requestor
CONFIG_ENABLE_OTA_REQUESTOR=y

# Enable chip shell
CONFIG_ENABLE_CHIP_SHELL=y

# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y