#
#    Copyright (c) 2021 Project CHIP Authors
#    All rights reserved.
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#
#    Description:
#      Some useful defaults for the demo app configuration.
#

#enable BT
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y

#disable BT connection reattempt
CONFIG_BT_NIMBLE_ENABLE_CONN_REATTEMPT=n

#enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y

#enable debug shell
CONFIG_ENABLE_CHIP_SHELL=y

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_FILENAME="partitions.csv"

#enable lwIP route hooks
CONFIG_LWIP_HOOK_IP6_ROUTE_DEFAULT=y
CONFIG_LWIP_HOOK_ND6_GET_GW_DEFAULT=y

# Serial Flasher config
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"

# Disable softap support by default
CONFIG_ESP_WIFI_SOFTAP_SUPPORT=n
# This example uses the older version of RMT driver to work with both
# idf-v4.4.3 and idf-v5.0, so suppressing the warnings by setting below option
CONFIG_RMT_SUPPRESS_DEPRECATE_WARN=y

# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y

# Disable Read Client
CONFIG_DISABLE_READ_CLIENT=y

# Increase LwIP IPv6 address number
CONFIG_LWIP_IPV6_NUM_ADDRESSES=6

# Enable sntp time sync
CONFIG_ENABLE_SNTP_TIME_SYNC=y

# Enable EVSE device on EP1
CONFIG_CHIP_DEVICE_CONFIG_ENABLE_EVSE=y

# Enable test triggers used by the Device Energy Management tests
CONFIG_CHIP_DEVICE_CONFIG_ENABLE_DEVICE_ENERGY_MANAGEMENT_TRIGGER=y

# Enable test triggers used by the Evse tests
CONFIG_CHIP_DEVICE_CONFIG_ENABLE_ENERGY_EVSE_TRIGGER=y

# Enable test triggers used by the Water Heater Management tests
CONFIG_CHIP_DEVICE_CONFIG_ENABLE_WATER_HEATER_MANAGEMENT_TRIGGER=y

# Enable test triggers used by the Electrical Reporting tests
CONFIG_CHIP_DEVICE_CONFIG_ENABLE_ENERGY_REPORTING_TRIGGER=y

# Ensure kPowerForecastReporting (PFR) is set in the DeviceEnergyManagement::Feature attribute. Note cannot set PFR and SFR.
CONFIG_DEM_SUPPORT_POWER_FORECAST_REPORTING=y

# Enable OTA Requestor
CONFIG_ENABLE_OTA_REQUESTOR=y