#
#    Copyright (c) 2020 Project CHIP Authors
#    Copyright (c) 2018 Nest Labs, Inc.
#    All rights reserved.
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#
#    Description:
#      Some useful defaults for the demo app configuration.
#


# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200

#enable BT
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y

#disable BT connection reattempt
CONFIG_BT_NIMBLE_ENABLE_CONN_REATTEMPT=n

#enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions.csv"

# Vendor and product id
CONFIG_DEVICE_VENDOR_ID=0xFFF1
CONFIG_DEVICE_PRODUCT_ID=0x8001
CONFIG_DEVICE_FIRMWARE_REVISION="prerelease"

#enable debug shell
CONFIG_ENABLE_CHIP_SHELL=y

#enable lwIP route hooks
CONFIG_LWIP_HOOK_IP6_ROUTE_DEFAULT=y
CONFIG_LWIP_HOOK_ND6_GET_GW_DEFAULT=y

# Serial Flasher config
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"

# Disable softap support by default
CONFIG_ESP_WIFI_SOFTAP_SUPPORT=n

# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y

# This example uses the older version of RMT driver to work with both
# idf-v4.4.3 and idf-v5.0, so supressing the warnings by setting below option
CONFIG_RMT_SUPPRESS_DEPRECATE_WARN=y

# Move functions from IRAM to flash
CONFIG_FREERTOS_PLACE_FUNCTIONS_INTO_FLASH=y