# Kconfig - ADC configuration options

#
# Copyright (c) 2015 Intel Corporation
#
# SPDX-License-Identifier: Apache-2.0
#

menuconfig ADC_DW
	bool "ARC Designware Driver"
	depends on ARC
	select ADC_0
	help
	  Enable the driver implementation of the Designware ADC IP.

if ADC_DW


config ADC_DW_CALIBRATION
	bool "Enable Calibration"
	default y
	help
	  Enables ADC to run with a calibrated output at the
	  expense of execution speed when exiting low power states.
	  If disabled, the ADC will require the application/system-integrator
	  to provide a calibration method.

config ADC_DW_DUMMY_CONVERSION
	bool "Enable dummy conversion"
	default y
	help
	  After awaking from low power state a dummy
	  conversion must be performed and discarded.
	  If disabled the user will have to discard the first
	  sample after a resume from a low power state.

choice
	prompt "Output Mode"
	default ADC_DW_SERIAL
	help
	  ADC output mode: parallel or serial.

config ADC_DW_SERIAL
	bool "Serial"

config ADC_DW_PARALLEL
	bool "Parallel"

endchoice

choice
	prompt "Sequence Mode"
	default ADC_DW_SINGLESHOT
	help
	  ADC sequence mode - single run/repetitive

config ADC_DW_SINGLESHOT
	bool "Single Ended"

config ADC_DW_REPETITIVE
	bool "Differential"

endchoice

choice
	prompt "Capture Mode"
	default ADC_DW_RISING_EDGE
	help
	  ADC controller capture mode:
	  by rising or falling edge of adc_clk

config ADC_DW_RISING_EDGE
	bool "Rising Edge"

config ADC_DW_FALLING_EDGE
	bool "Falling Edge"

endchoice

config ADC_DW_SAMPLE_WIDTH
	int "Sample Width"
	default 31
	help
	  Defines ADC device data sample width (resolution):

	  - 0 = 6 bits resolution

	  - 1 = 8 bits resolution

	  - 2 = 10 bits resolution

	  - 3 = 12 bits resolution

config ADC_DW_SERIAL_DELAY
	int "Serial Delay"
	default 1
	help
	  Number of ADC clock ticks that the first bit of
	  the serial output is delayed after the conversion
	  has started.

config ADC_DW_CLOCK_RATIO
	int "Clock Ratio"
	default 1024
	help
	  ADC Clock Ratio

endif # ADC_DW