/*
 * Copyright (c) 2018 Linaro Limited
 *
 * SPDX-License-Identifier: Apache-2.0
 */
#include <mem.h>
#include <st/f0/stm32f070.dtsi>

/ {
	sram0: memory@20000000 {
		reg = <0x20000000 DT_SIZE_K(16)>;
	};

	soc {
		flash-controller@40022000 {
			flash0: flash@8000000 {
				erase-block-size = <2048>;
				reg = <0x08000000 DT_SIZE_K(128)>;
			};
		};

		/*
		 * USARTs 3-4 share the same IRQ on stm32f070Xb devices. This
		 * configuration is not currently supported, so at most one of
		 * these may be enabled at a time. Enabling more than one will
		 * result in a build failure.
		 */
		usart3: serial@40004800 {
			compatible = "st,stm32-usart", "st,stm32-uart";
			reg = <0x40004800 0x400>;
			clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00040000>;
			resets = <&rctl STM32_RESET(APB1, 18U)>;
			interrupts = <29 0>;
			status = "disabled";
		};

		usart4: serial@40004c00 {
			compatible = "st,stm32-usart", "st,stm32-uart";
			reg = <0x40004c00 0x400>;
			clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00080000>;
			resets = <&rctl STM32_RESET(APB1, 19U)>;
			interrupts = <29 0>;
			status = "disabled";
		};

		i2c2: i2c@40005800 {
			compatible = "st,stm32-i2c-v2";
			clock-frequency = <I2C_BITRATE_STANDARD>;
			#address-cells = <1>;
			#size-cells = <0>;
			reg = <0x40005800 0x400>;
			clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00400000>;
			interrupts = <24 0>;
			interrupt-names = "combined";
			status = "disabled";
		};

		spi2: spi@40003800 {
			compatible = "st,stm32-spi-fifo", "st,stm32-spi";
			#address-cells = <1>;
			#size-cells = <0>;
			reg = <0x40003800 0x400>;
			clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00004000>;
			interrupts = <26 3>;
			status = "disabled";
		};

		timers6: timers@40001000 {
			compatible = "st,stm32-timers";
			reg = <0x40001000 0x400>;
			clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00000010>;
			resets = <&rctl STM32_RESET(APB1, 4U)>;
			interrupts = <17 0>;
			interrupt-names = "global";
			st,prescaler = <0>;
			status = "disabled";
		};

		timers7: timers@40001400 {
			compatible = "st,stm32-timers";
			reg = <0x40001400 0x400>;
			clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00000020>;
			resets = <&rctl STM32_RESET(APB1, 5U)>;
			interrupts = <18 0>;
			interrupt-names = "global";
			st,prescaler = <0>;
			status = "disabled";
		};
	};

	smbus2: smbus2 {
		compatible = "st,stm32-smbus";
		#address-cells = <1>;
		#size-cells = <0>;
		i2c = <&i2c2>;
		status = "disabled";
	};
};