description: Kinetis LPUART

compatible: "nxp,kinetis-lpuart"

include: [uart-controller.yaml, pinctrl-device.yaml]

properties:
  reg:
    required: true

  nxp,loopback:
    type: boolean
    description: |
      Enable loopback mode on LPUART peripheral. When present, RX pin is
      disconnected, and transmitter output is internally connected to
      the receiver input.

  nxp,rs485-mode:
    type: boolean
    description: |
      Set to enable RTS signal, which can be used to enable the driver
      of an external RS-485 transceiver. Note hw-flow-control should be
      set to false.

  nxp,rs485-de-active-low:
    type: boolean
    description: RTS polarity at RS485 mode.