include: [uart-controller.yaml, pinctrl-device.yaml]

properties:
  reg:
    required: true

  interrupts:
    required: true

  disable-rx:
    type: boolean
    description: |
      Disable UART reception capabilities (only required to disable reception
      if CONFIG_PINCTRL is enabled).

  current-speed:
    description: |
      Initial baud rate setting for UART. Only a fixed set of baud
      rates are selectable on these devices.
    enum:
      - 1200
      - 2400
      - 4800
      - 9600
      - 14400
      - 19200
      - 28800
      - 31250
      - 38400
      - 56000
      - 57600
      - 76800
      - 115200
      - 230400
      - 250000
      - 460800
      - 921600
      - 1000000

  tx-pin:
    type: int
    deprecated: true
    description: |
      IMPORTANT: This option will only be used if the new pin control driver
      is not enabled.

      The TX pin to use.

      For pins P0.0 through P0.31, use the pin number. For example,
      to use P0.16 for TX, set:

        tx-pin = <16>;

      For pins P1.0 through P1.31, add 32 to the pin number. For
      example, to use P1.2 for TX, set:

        tx-pin = <34>;  /* 32 + 2 */

  rx-pin:
    type: int
    deprecated: true
    description: |
      IMPORTANT: This option will only be used if the new pin control driver
      is not enabled.

      The RX pin to use. The pin numbering scheme is the same as the
      tx-pin property's.

  rts-pin:
    type: int
    deprecated: true
    description: |
      IMPORTANT: This option will only be used if the new pin control driver
      is not enabled.

      The RTS pin to use. The pin numbering scheme is the same as the
      tx-pin property's.

  cts-pin:
    type: int
    deprecated: true
    description: |
      IMPORTANT: This option will only be used if the new pin control driver
      is not enabled.

      The CTS pin to use. The pin numbering scheme is the same as the
      tx-pin property's.

  rx-pull-up:
    type: boolean
    deprecated: true
    description: |
      IMPORTANT: This option will only be used if the new pin control driver
      is not enabled.

      Enable pull-up resistor on the RX pin.

  cts-pull-up:
    type: boolean
    deprecated: true
    description: |
      IMPORTANT: This option will only be used if the new pin control driver
      is not enabled.

      Enable pull-up resistor on the CTS pin.