# Kconfig - ETH_ENC28J60 Ethernet driver configuration options

#
# Copyright (c) 2015 Intel Corporation
#
# SPDX-License-Identifier: Apache-2.0
#

menuconfig ETH_ENC28J60
	bool "ENC28J60C Ethernet Controller"
	depends on SPI
	help
	  ENC28J60C Stand-Alone Ethernet Controller
	  with SPI Interface

config ETH_ENC28J60_RX_THREAD_STACK_SIZE
	int "Stack size for internal incoming packet handler"
	depends on ETH_ENC28J60
	default 800
	help
	  Size of the stack used for internal thread which is ran for
	  incoming packet processing.

config ETH_ENC28J60_RX_THREAD_PRIO
	int "Priority for internal incoming packet handler"
	depends on ETH_ENC28J60
	default 2
	help
	  Priority level for internal thread which is ran for incoming
	  packet processing.

config ETH_ENC28J60_TIMEOUT
	int "IP buffer timeout"
	depends on ETH_ENC28J60
	default 100
	help
	  Given timeout in milliseconds. Maximum amount of time
	  that the driver will wait from the IP stack to get
	  a memory buffer before the Ethernet frame is dropped.

config ETH_ENC28J60_0
	bool "ENC28J60C Ethernet port 0"
	depends on ETH_ENC28J60
	help
	  Include port 0 driver

if ETH_ENC28J60 && ETH_ENC28J60_0
config ETH_ENC28J60_0_FULL_DUPLEX
	bool "ENC28J60 full duplex"
	default y
	help
	  Enable Full Duplex. Device is configured half duplex
	  when disabled.

config ETH_ENC28J60_0_GPIO_SPI_CS
	bool "Manage SPI CS through a GPIO pin"
	help
	This option is useful if one needs to manage SPI CS through a GPIO
	pin to by-pass the SPI controller's CS logic.

endif #ETH_ENC28J60 && ETH_ENC28J60_0