spi1: &scb3 {
	compatible = "infineon,cat1-spi";
	status = "okay";

	pinctrl-0 = <&p6_0_scb3_spi_m_mosi &p6_1_scb3_spi_m_miso &p6_2_scb3_spi_m_clk>;
	pinctrl-names = "default";
	cs-gpios = <&gpio_prt6 3 GPIO_ACTIVE_LOW>;

	slow@0 {
		compatible = "test-spi-loopback-slow";
		reg = <0>;
		spi-max-frequency = <2000000>;
	};
	fast@0 {
		compatible = "test-spi-loopback-fast";
		reg = <0>;
		spi-max-frequency = <3000000>;
	};
};

&gpio_prt6 {
	status = "okay";
};

&pinctrl {
	/* Configure pin control bias mode for SPI pins */
	p6_0_scb3_spi_m_mosi: p6_0_scb3_spi_m_mosi {
		pinmux = <DT_CAT1_PINMUX(6, 0, HSIOM_SEL_ACT_8)>;
		drive-push-pull;
	};

	p6_1_scb3_spi_m_miso: p6_1_scb3_spi_m_miso {
		pinmux = <DT_CAT1_PINMUX(6, 1, HSIOM_SEL_ACT_8)>;
		input-enable;
	};

	p6_2_scb3_spi_m_clk: p6_2_scb3_spi_m_clk {
		pinmux = <DT_CAT1_PINMUX(6, 2, HSIOM_SEL_ACT_8)>;
		drive-push-pull;
	};
};