# Copyright (c) 2018, Phytec Messtechnik GmbH
# SPDX-License-Identifier: Apache-2.0

description: SSD16XX 250x150 EPD display controller

compatible: "solomon,ssd16xxfb"

include: [spi-device.yaml, display-controller.yaml]

properties:
    pp-height-bits:
      type: int
      required: true
      description: Number of bits used for the height parameters

    pp-width-bits:
      type: int
      required: true
      description: Number of bits used for the width parameters

    gdv:
      type: uint8-array
      required: true
      description: Gate driving voltage values

    sdv:
      type: uint8-array
      required: true
      description: Source driving voltage values

    vcom:
      type: int
      required: true
      description: VCOM voltage

    border-waveform:
      type: int
      required: true
      description: Border waveform

    softstart:
      type: uint8-array
      required: false
      description: Booster soft start values

    orientation-flipped:
      type: boolean
      required: false
      description: Last column address is mapped to first segment

    reset-gpios:
      type: phandle-array
      required: true
      description: RESET pin.

        The RESET pin of SSD16XX is active low.
        If connected directly the MCU pin should be configured
        as active low.

    dc-gpios:
      type: phandle-array
      required: true
      description: DC pin.

        The DC pin of SSD16XX is active low (transmission command byte).
        If connected directly the MCU pin should be configured
        as active low.

    busy-gpios:
      type: phandle-array
      required: true
      description: BUSY pin.

        The BUSY pin of SSD16XX is active high.
        If connected directly the MCU pin should be configured
        as active high.

    lut-initial:
      type: uint8-array
      required: false

    lut-default:
      type: uint8-array
      required: false

    tssv:
      type: int
      required: false
      description: Temperature Sensor Selection Value

        Display controller can have integrated temperature sensor or
        an external temperature sensor is connected to the controller.
        The value selects which sensor should be used.