# Copyright (c) 2018 STMicroelectronics
# Copyright (c) 2024 SILA Embedded Solutions GmbH
# SPDX-License-Identifier: Apache-2.0

include: sensor-device.yaml

properties:
  int1-gpios:
    type: phandle-array
    description: |
      INT_1 pin

      This pin defaults to active high when produced by the sensor. The property value should ensure
      the flags properly describe the signal that is presented to the driver.

  int2-gpios:
    type: phandle-array
    description: |
      INT_2 pin

      This pin defaults to active high when produced by the sensor. The property value should ensure
      the flags properly describe the signal that is presented to the driver.

  drdy-int-pad:
    type: int
    enum: [1, 2]
    description: |
      Select DRDY pin number (1 or 2).

      This number represents which of the two interrupt pins (INT_1 or INT_2), if any, the DRDY
      interrupt should be generated from. If this property is not specified, no data ready
      interrupts can be registered.

      - 1 # drdy is generated on INT1
      - 2 # drdy is generated on INT2

  threshold-int-pad:
    type: int
    enum: [1, 2]
    description: |
      Select threshold interrupt pin number (1 or 2).

      This number represents which of the two interrupt pins (INT_1 or INT_2), if any, the threshold
      interrupt should be generated from. If this property is not specified, no threshold interrupts
      can be registered.

      - 1 # threshold interrupt is generated on INT1
      - 2 # threshold interrupt is generated on INT2

  range:
    type: int
    default: 2
    description: |
      Range in g. Default is power-up configuration.

      - 16 # 16g (1.952 mg/LSB)
      - 8  #  8g (0.976 mg/LSB)
      - 4  #  4g (0.488 mg/LSB)
      - 2  #  2g (0.244 mg/LSB)

    enum: [16, 8, 4, 2]