# Zephyr Kernel Configuration
CONFIG_ARM=y
CONFIG_ARCH="arm"
CONFIG_SOC="stm32f373xc"
CONFIG_SOC_SERIES="stm32f3"
CONFIG_SOC_FAMILY="st_stm32"
CONFIG_BOARD="stm32373c_eval"
CONFIG_SOC_SERIES_STM32F3X=y

# Platform Configuration
CONFIG_SOC_FAMILY_STM32=y
CONFIG_SOC_STM32F373XC=y
CONFIG_BOARD_STM32373C_EVAL=y

# ARM Options
CONFIG_CPU_HAS_FPU=y

# Floating Point Options
CONFIG_FLOAT=y

# General Kernel Options
CONFIG_CORTEX_M_SYSTICK=y
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000

# Serial Drivers
CONFIG_SERIAL=y
CONFIG_SERIAL_HAS_DRIVER=y
CONFIG_UART_INTERRUPT_DRIVEN=y
CONFIG_UART_STM32=y
# enable USART2 - passthrough to STLINK v2 connector
CONFIG_UART_STM32_PORT_2=y
CONFIG_UART_STM32_PORT_2_NAME="UART_2"
CONFIG_UART_STM32_PORT_2_BAUD_RATE=115200
# enable console on this port by default
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y
CONFIG_UART_CONSOLE_ON_DEV_NAME="UART_2"

# Pinmux Driver
CONFIG_PINMUX=y
CONFIG_PINMUX_STM32=y

# GPIO Controller
CONFIG_GPIO=y
CONFIG_GPIO_STM32=y
CONFIG_GPIO_STM32_PORTA=y
CONFIG_GPIO_STM32_PORTB=y
CONFIG_GPIO_STM32_PORTC=y
CONFIG_GPIO_STM32_PORTD=y
CONFIG_GPIO_STM32_PORTE=y

# Clock configuration
CONFIG_CLOCK_CONTROL=y
CONFIG_CLOCK_CONTROL_STM32_CUBE=y
# SYSCLK selection
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
# HSE configuration
CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
# PLL configuration
CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
# produce 72MHz clock at PLL output
CONFIG_CLOCK_STM32_PLL_PREDIV=1
CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9
CONFIG_CLOCK_STM32_AHB_PRESCALER=1
CONFIG_CLOCK_STM32_APB1_PRESCALER=2
CONFIG_CLOCK_STM32_APB2_PRESCALER=2