description: Kinetis LPUART

compatible: "nxp,kinetis-lpuart"

include: [uart-controller.yaml, pinctrl-device.yaml]

properties:
    reg:
      required: true

    interrupts:
      required: true

    nxp,loopback:
      type: boolean
      description: |
        Enable loopback mode on LPUART peripheral. When present, RX pin is
        disconnected, and transmitter output is internally connected to
        the receiver input.

    nxp,rs485-mode:
      type: boolean
      required: false
      description: |
        Set to enable RTS signal, which can be used to enable the driver
        of an external RS-485 transceiver. Note hw-flow-control should be
        set to false.

    nxp,rs485-de-active-low:
      type: boolean
      required: false
      description: RTS polarity at RS485 mode.