| /* |
| * Copyright (c) 2018 Intel Corporation. |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #include <mem.h> |
| #include <st/f0/stm32f030.dtsi> |
| |
| / { |
| sram0: memory@20000000 { |
| reg = <0x20000000 DT_SIZE_K(32)>; |
| }; |
| |
| soc { |
| flash-controller@40022000 { |
| flash0: flash@8000000 { |
| reg = <0x08000000 DT_SIZE_K(256)>; |
| }; |
| }; |
| |
| spi2: spi@40003800 { |
| compatible = "st,stm32-spi-fifo", "st,stm32-spi"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| reg = <0x40003800 0x400>; |
| clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00004000>; |
| interrupts = <26 3>; |
| status = "disabled"; |
| }; |
| |
| /* |
| * USARTs 3-6 share the same IRQ on stm32f030Xc devices. This |
| * configuration is not currently supported, so at most one of |
| * these may be enabled at a time. Enabling more than one will |
| * result in a build failure. |
| */ |
| usart3: serial@40004800 { |
| compatible = "st,stm32-usart", "st,stm32-uart"; |
| reg = <0x40004800 0x400>; |
| clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00040000>; |
| interrupts = <29 0>; |
| status = "disabled"; |
| }; |
| |
| usart4: serial@40004c00 { |
| compatible = "st,stm32-usart", "st,stm32-uart"; |
| reg = <0x40004c00 0x400>; |
| clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00080000>; |
| interrupts = <29 0>; |
| status = "disabled"; |
| }; |
| |
| usart5: serial@40005000 { |
| compatible = "st,stm32-usart", "st,stm32-uart"; |
| reg = <0x40005000 0x400>; |
| clocks = <&rcc STM32_CLOCK_BUS_APB1 0x00100000>; |
| interrupts = <29 0>; |
| status = "disabled"; |
| }; |
| |
| usart6: serial@40011400 { |
| compatible = "st,stm32-usart", "st,stm32-uart"; |
| reg = <0x40011400 0x400>; |
| clocks = <&rcc STM32_CLOCK_BUS_APB2 0x00000020>; |
| interrupts = <29 0>; |
| status = "disabled"; |
| }; |
| }; |
| }; |