# Copyright (c) 2020 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

description: |
    When setting the range, odr properties in a .dts or .dtsi file you may
    include iis2iclx.h and use the macros defined there.

    Example:
    #include <zephyr/dt-bindings/sensor/iis2iclx.h>

    iis2iclx: iis2iclx@0 {
      ...

      range = <IIS2ICLX_DT_FS_2G>;
      odr = <IIS2ICLX_DT_ODR_833Hz>;
    };

include: sensor-device.yaml

properties:
  drdy-gpios:
    type: phandle-array
    description: |
      DRDY pin

      This pin defaults to active high when produced by the sensor.
      The property value should ensure the flags properly describe
      the signal that is presented to the driver.

  int-pin:
    type: int
    default: 1
    enum: [1, 2]
    description: |
      Select DRDY pin number (1 or 2).

      This number represents which of the two interrupt pins
      (INT1 or INT2) the drdy line is attached to. This property is not
      mandatory and if not present it defaults to 1 which is the
      configuration at power-up.

      - 1 # drdy is generated from INT1
      - 2 # drdy is generated from INT2

  range:
    type: int
    default: 3
    description: |
      Range in g. Default is power-up configuration.

      - 0 # IIS2ICLX_DT_FS_500mG (0.015 mg/LSB)
      - 1 # IIS2ICLX_DT_FS_3G    (0.122 mg/LSB)
      - 2 # IIS2ICLX_DT_FS_1G    (0.031 mg/LSB)
      - 3 # IIS2ICLX_DT_FS_2G    (0.061 mg/LSB)

    enum: [0, 1, 2, 3]

  odr:
    type: int
    default: 0
    description: |
      Specify the default accelerometer output data rate expressed in samples per second (Hz).
      Default is power-up configuration.

      - 0  # IIS2ICLX_DT_ODR_OFF
      - 1  # IIS2ICLX_DT_ODR_12Hz5
      - 2  # IIS2ICLX_DT_ODR_26H
      - 3  # IIS2ICLX_DT_ODR_52Hz
      - 4  # IIS2ICLX_DT_ODR_104Hz
      - 5  # IIS2ICLX_DT_ODR_208Hz
      - 6  # IIS2ICLX_DT_ODR_416Hz
      - 7  # IIS2ICLX_DT_ODR_833Hz

    enum: [0, 1, 2, 3, 4, 5, 6, 7]