| description: Kinetis LPUART |
| |
| compatible: "nxp,kinetis-lpuart" |
| |
| include: [uart-controller.yaml, uart-controller-pin-inversion.yaml, pinctrl-device.yaml] |
| |
| properties: |
| reg: |
| required: true |
| |
| nxp,loopback: |
| type: boolean |
| description: | |
| Enable loopback mode on LPUART peripheral. When present, RX pin is |
| disconnected, and transmitter output is internally connected to |
| the receiver input. |
| |
| single-wire: |
| type: boolean |
| description: | |
| Enable the single wire half-duplex communication. |
| Using this mode, TX and RX lines are internally connected and |
| only TX pin is used afterwards and should be configured. |
| RX/TX conflicts must be handled on user side. |
| |
| nxp,rs485-mode: |
| type: boolean |
| description: | |
| Set to enable RTS signal, which can be used to enable the driver |
| of an external RS-485 transceiver. Note hw-flow-control should be |
| set to false. |
| |
| nxp,rs485-de-active-low: |
| type: boolean |
| description: RTS polarity at RS485 mode. |
