# Note: Using OpenOCD using nucloe_wba52cg requires using openocd fork.
# See board documentation for more information

source [find interface/stlink-dap.cfg]

set WORKAREASIZE 0x8000

transport select "dapdirect_swd"

# Enable debug when in low power modes
set ENABLE_LOW_POWER 1

# Stop Watchdog counters when halt
set STOP_WATCHDOG 1

# STlink Debug clock frequency
set CLOCK_FREQ 8000

# Reset configuration
# use hardware reset, connect under reset
# connect_assert_srst needed if low power mode application running (WFI...)
reset_config srst_only srst_nogate

source [find target/stm32wbax.cfg]

gdb_memory_map disable