# Copyright 2020 NXP
# SPDX-License-Identifier: Apache-2.0

description: NXP FlexSPI device

include: [spi-device.yaml, "jedec,jesd216.yaml"]

properties:
  cs-interval-unit:
    type: int
    default: 1
    enum:
      - 1
      - 256
    description: |
      Chip select interval units, in serial clock cycles. See the
      CSINTERVALUNIT field in registers FLASHA1CR0 through FLASHB2CR0. The
      default corresponds to the reset value of the register field.

  cs-interval:
    type: int
    default: 0
    description: |
      Minimum interval between chip select deassertion and assertion. See the
      CSINTERVAL field in registers FLASHA1CR0 through FLASHB2CR0. The
      default corresponds to the reset value of the register field.

  cs-setup-time:
    type: int
    default: 3
    description: |
      Chip select setup time, in serial clock cycles. See the TCSS field in
      registers FLASHA1CR0 through FLASHB2CR0. The default corresponds to the
      reset value of the register field.

  cs-hold-time:
    type: int
    default: 3
    description: |
      Chip select hold time, in serial clock cycles. See the TCSH field in
      registers FLASHA1CR0 through FLASHB2CR0. The default corresponds to the
      reset value of the register field.

  data-valid-time:
    type: int
    default: 0
    description: |
      Data valid time, in nanoseconds. See the registers DLLACR through
      DLLBCR.

  column-space:
    type: int
    default: 0
    description: |
      Column address bit width. Set to zero if the flash does not support
      column address. See the CAS field in registers FLASHA1CR0 through
      FLASHB2CR0. The default corresponds to the reset value of the register
      field.

  word-addressable:
    type: boolean
    description: |
      Don't transmit the least significant address bit when the flash is word
      addressable. See the WA field in registers FLASHA1CR0 through
      FLASHB2CR0.

  ahb-write-wait-unit:
    type: int
    default: 2
    enum:
      - 2
      - 8
      - 32
      - 128
      - 512
      - 2048
      - 8192
      - 32768
    description: |
      AHB write wait interval units, in AHB clock cycles. See the AWRWAITUNIT
      field in registers FLASHA1CR2 through FLASHB2CR2. The default
      corresponds to the reset value of the register field.

  ahb-write-wait-interval:
    type: int
    default: 0
    description: |
      Time to wait between AHB triggered command sequences. See the AWRWAIT
      field in registers FLASHA1CR2 through FLASHB2CR2. The default
      corresponds to the reset value of the register field.