blob: f6c19960b3c85ca24de62f4a3db0af438fa12c1f [file] [log] [blame]
.. zephyr:board:: m5stack_fire
Overview
********
M5Stack Fire is an ESP32-based development board from M5Stack.
Hardware
********
M5Stack Fire features the following integrated components:
- ESP32-D0WDQ6 chip (240MHz dual core, 600 DMIPS, 520KB SRAM, Wi-Fi)
- PSRAM 8MB
- Flash 16MB
- LCD IPS TFT 2", 320x240 px screen (ILI9342C)
- Charger IP5306
- Audio NS4148 amplifier (1W-092 speaker)
- USB CH9102F
- SD-Card slot
- Grove connector
- IMO 6-axis IMU MPU6886
- MIC BSE3729
- Battery 500mAh 3,7V
- Three physical buttons
- LED strips
.. include:: ../../../espressif/common/soc-esp32-features.rst
:start-after: espressif-soc-esp32-features
Supported Features
==================
.. zephyr:board-supported-hw::
Functional Description
======================
The following table below describes the key components, interfaces, and controls
of the M5Stack Core2 board.
.. _M5Core2 Schematic: https://m5stack-doc.oss-cn-shenzhen.aliyuncs.com/480/M5-Core-Schematic_20171206.pdf
.. _MPU-ESP32: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/esp32_datasheet_en_v3.9.pdf
.. _MPU-6886: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/MPU-6886-000193%2Bv1.1_GHIC_en.pdf
.. _LCD-ILI9342C: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/ILI9342C-ILITEK.pdf
.. _IP5306: https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/docs/datasheet/core/IIC_IP5306_REG_V1.4_cn.pdf
+------------------+------------------------------------------------------------------------+-----------+
| Key Component | Description | Status |
+==================+========================================================================+===========+
| ESP32-D0WDQ6-V2 | This `MPU-ESP32`_ module provides complete Wi-Fi and Bluetooth | supported |
| module | functionalities and integrates a 16-MB SPI flash. | |
+------------------+------------------------------------------------------------------------+-----------+
| USB Port | USB interface. Power supply for the board as well as the | supported |
| | communication interface between a computer and the board. | |
+------------------+------------------------------------------------------------------------+-----------+
| Power Switch | Power on/off button. | supported |
+------------------+------------------------------------------------------------------------+-----------+
| General purpose | Three buttons on the front face of the device accessible using the | supported |
| buttons | GPIO interface. | |
+------------------+------------------------------------------------------------------------+-----------+
| LCD screen | Built-in LCD TFT display \(`LCD-ILI9342C`_, 2", 320x240 px\) | supported |
| | controlled via SPI interface | |
+------------------+------------------------------------------------------------------------+-----------+
| SD-Card slot | SD-Card connection via SPI-mode. | supported |
+------------------+------------------------------------------------------------------------+-----------+
| 6-axis IMU | The `MPU-6886`_ is a 6-axis motion tracker (6DOF IMU) device that | supported |
| MPU6886 | combines a 3-axis gyroscope and a 3-axis accelerometer. | |
+------------------+------------------------------------------------------------------------+-----------+
| Grove port | Used to interface with the many available modules and sensors. | supported |
+------------------+------------------------------------------------------------------------+-----------+
| Built-in speaker | 1W speaker for analog audio output. | supported |
+------------------+------------------------------------------------------------------------+-----------+
| Built-in | The BSE3729 analog microphone. | todo |
| microphone | | |
+------------------+------------------------------------------------------------------------+-----------+
| LED strip | LED strips on the side of the device. | todo |
+------------------+------------------------------------------------------------------------+-----------+
| Battery-support | Charging is supported automatically via the `IP5306`_. But there is no | todo |
| | possibility to query current battery status. | |
+------------------+------------------------------------------------------------------------+-----------+
System Requirements
*******************
.. include:: ../../../espressif/common/system-requirements.rst
:start-after: espressif-system-requirements
Programming and Debugging
*************************
.. zephyr:board-supported-runners::
.. include:: ../../../espressif/common/building-flashing.rst
:start-after: espressif-building-flashing
.. include:: ../../../espressif/common/board-variants.rst
:start-after: espressif-board-variants
Debugging
=========
M5Stack Fire debugging is not supported due to pinout limitations.
Related Documents
*****************
.. target-notes::
.. _`M5Stack-Fire schematic`: https://m5stack-doc.oss-cn-shenzhen.aliyuncs.com/480/M5-Core-Schematic_20171206.pdf
.. _`M5Stack-Fire docs`: https://docs.m5stack.com/en/core/fire_v2.7
.. _`ESP32 Hardware Reference`: https://docs.espressif.com/projects/esp-idf/en/latest/esp32/hw-reference/index.html