# Copyright (c) 2020 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

include: sensor-device.yaml

properties:
    drdy-gpios:
      type: phandle-array
      description: DRDY pin

        This pin defaults to active high when produced by the sensor.
        The property value should ensure the flags properly describe
        the signal that is presented to the driver.

    int-pin:
      type: int
      default: 1
      enum:
        - 1 # drdy is generated from INT1
        - 2 # drdy is generated from INT2
      description: Select DRDY pin number (1 or 2).

        This number represents which of the two interrupt pins
        (INT1 or INT2) the drdy line is attached to. This property is not
        mandatory and if not present it defaults to 1 which is the
        configuration at power-up.

    range:
      type: int
      default: 3
      description: Range in g. Default is power-up configuration.
      enum:
        - 0 # 500mg (0.015 mg/LSB)
        - 1 # 3g    (0.122 mg/LSB)
        - 2 # 1g    (0.031 mg/LSB)
        - 3 # 2g    (0.061 mg/LSB)

    odr:
      type: int
      default: 0
      description:
          Specify the default accelerometer output data rate expressed in samples per second (Hz).
          Default is power-up configuration.
      enum:
        - 0  # Power-Down
        - 1  # 12.5Hz
        - 2  # 26Hz
        - 3  # 52Hz
        - 4  # 104Hz
        - 5  # 208Hz
        - 6  # 416Hz
        - 7  # 833Hz
        - 8  # 1660Hz
        - 9  # 3330Hz
        - 10 # 6660Hz