CONFIG_ARM=y
CONFIG_BOARD_STM32F3_DISCO=y
CONFIG_SOC_SERIES_STM32F3X=y
CONFIG_SOC_STM32F303XC=y
# 72MHz system clock
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000
CONFIG_SYS_CLOCK_TICKS_PER_SEC=1000

# ARM Options
CONFIG_CPU_HAS_FPU=y

# Floating Point Options
CONFIG_FLOAT=y

# enable uart driver
CONFIG_SERIAL=y
CONFIG_UART_STM32=y
# enable USART1 - passthrough to STLINK v2-1 connector
CONFIG_UART_STM32_PORT_1=y
# enable console on this port by default
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y

#enable I2C
CONFIG_I2C=y
CONFIG_I2C_STM32_V2=y

# enable pinmux
CONFIG_PINMUX=y
CONFIG_PINMUX_STM32=y

# enable GPIO ports A, B, E
CONFIG_GPIO=y
CONFIG_GPIO_STM32=y
CONFIG_GPIO_STM32_PORTA=y
CONFIG_GPIO_STM32_PORTB=y
CONFIG_GPIO_STM32_PORTE=y
CONFIG_GPIO_STM32_PORTF=y

# clock configuration
CONFIG_CLOCK_CONTROL=y

# Clock configuration for Cube Clock control driver
CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
# use HSE as PLL input
CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
# however, the board does not have an external oscillator, so just use
# the 8MHz clock signal coming from integrated STLink
CONFIG_CLOCK_STM32_HSE_BYPASS=y
# produce 72MHz clock at PLL output
CONFIG_CLOCK_STM32_PLL_PREDIV=1
CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9
CONFIG_CLOCK_STM32_AHB_PRESCALER=1
CONFIG_CLOCK_STM32_APB1_PRESCALER=2
CONFIG_CLOCK_STM32_APB2_PRESCALER=1