| # nRF52840 Dongle NRF52840 board configuration |
| # |
| # Copyright (c) 2018 Nordic Semiconductor ASA |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| if BOARD_NRF52840DONGLE_NRF52840 |
| |
| config BOARD |
| default "nrf52840dongle_nrf52840" |
| |
| # To let the nRF5 bootloader load an application, the application |
| # must be linked after Nordic MBR, that is factory-programmed on the board. |
| |
| # Nordic nRF5 bootloader exists outside of the partitions specified in the |
| # DTS file, so we manually override FLASH_LOAD_OFFSET to link the application |
| # correctly, after Nordic MBR. |
| |
| # When building MCUBoot, MCUBoot itself will select USE_DT_CODE_PARTITION |
| # which will make it link into the correct partition specified in DTS file, |
| # so no override is necessary. |
| |
| config FLASH_LOAD_OFFSET |
| default 0x1000 |
| depends on BOARD_HAS_NRF5_BOOTLOADER && !USE_DT_CODE_PARTITION |
| |
| if USB_DEVICE_STACK |
| |
| # Enable UART driver, needed for CDC ACM |
| config SERIAL |
| default y |
| |
| endif # USB_DEVICE_STACK |
| |
| config BT_CTLR |
| default BT |
| |
| endif # BOARD_NRF52840DONGLE_NRF52840 |
