# Copyright (c) 2020, Linaro limited
# SPDX-License-Identifier: Apache-2.0

description: |
    STM32 QSPI Flash controller supporting the JEDEC CFI interface

    Representation of a serial flash on a quadspi bus:

        mx25r6435f: qspi-nor-flash@0 {
                compatible = "st,stm32-qspi-nor";
                reg = <0>;
                qspi-max-frequency = <80000000>;
                size = <0x4000000>;
                reset-gpios = <&gpiod 3 GPIO_ACTIVE_LOW>;
                reset-gpios-duration = <1>;
                spi-bus-width = <4>;
                status = "okay";
        };

compatible: "st,stm32-qspi-nor"

include: ["flash-controller.yaml", "jedec,jesd216.yaml"]

on-bus: qspi

properties:
    reg:
      required: true
    qspi-max-frequency:
      type: int
      required: true
      description: Maximum clock frequency of device's QSPI interface in Hz
    size:
      required: true
      description: Flash Memory size in bits
    reset-gpios:
      type: phandle-array
      description: RESETn pin
    reset-gpios-duration:
      type: int
      description: The duration (in ms) for the flash memory reset pulse
    reset-cmd:
      type: boolean
      description: Send reset command on initialization
    reset-cmd-wait:
      type: int
      default: 10
      description: The duration (in us) to wait after reset command
    spi-bus-width:
      type: int
      description: The width of (Q)SPI bus to which flash memory is connected.
                   Now only value of 4 (when using SIO[0123]) is supported.
    writeoc:
      type: string
      enum:
        - "PP_1_1_4"      # Quad data line SPI, PP 1-1-4 (0x32)
        - "PP_1_4_4"      # Quad data line SPI, PP 1-4-4 (0x38)
      description: |
        The value encodes number of I/O lines used for the opcode,
        address, and data.

        There is no info about quad page program opcodes in the SFDP
        tables, hence it has been assumed that NOR flash memory
        supporting 1-4-4 mode also would support fast page programming.

        If absent, then 1-4-4 program page is used in quad mode.