# Copyright (c) 2022 Meta Platforms, Inc. and its affiliates.
# SPDX-License-Identifier: Apache-2.0

description: BMI08X Gyro inertial measurement unit

include: sensor-device.yaml

properties:
  int-gpios:
    type: phandle-array
    description: |
      This property specifies the connection for INT, because the
      Zephyr driver maps all interrupts to INT. The signal defaults
      to output low when produced by the sensor.

  int3-4-map-io:
    type: int
    description: |
      Bit[0] will map the data ready interrupt on INT3
      Bit[2] will map the fifo interrupt on INT3
      Bit[5] will map the fifo interrupt on INT4
      Bit[7] will enable the data ready interrupt on INT4

  int3-4-conf-io:
    type: int
    description: |
      Bit[0]: if set to 1, INT3 is active high, otherwise it's active low
      Bit[1]: if set to 1, INT3 is open-drain, otherwise it's push-pull
      Bit[2]: if set to 1, INT4 is active high, otherwise it's active low
      Bit[3]: if set to 1, INT4 is open-drain, otherwise it's push-pull

  gyro-hz:
    type: string
    required: true
    description: |
      Default frequency of accelerometer. (Unit - Hz)
    enum:
      - "2000_532"
      - "2000_230"
      - "1000_116"
      - "400_47"
      - "200_23"
      - "100_12"
      - "200_64"
      - "100_32"

  gyro-fs:
    type: int
    required: true
    description: |
      Default full scale of accelerometer. (Unit - g)
    enum:
      - 2000
      - 1000
      - 500
      - 250
      - 125

  data-sync:
    type: boolean
    description: |
      Enables data sync if defined. Must be set if bmi08x-accel data-sync is set as well.