# Copyright (c) 2024 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

description: |
    STMicroelectronics STTS22H temperature sensor connected to I2C bus
    When setting the sampling-rate property in a .dts or .dtsi file you
    may include stts22h.h and use the macros defined there.

    Example:
    #include <zephyr/dt-bindings/sensor/stts22h.h>

    stts22h: stts22h@0 {
      ...

      sampling-rate = <STTS22H_100Hz>;
    };

compatible: "st,stts22h"

include: [sensor-device.yaml, i2c-device.yaml]

properties:
  int-gpios:
    type: phandle-array
    description: interrupt pin

      This pin defaults to active high when produced by the sensor.
      The property value should ensure the flags properly describe
      the signal that is presented to the driver.

  temperature-hi-threshold:
    type: int
    default: 0
    description: |
      HIGH temperature threshold above which an alarm is triggered.
      Valid range is 0 to 255. It defaults to 0 (alarm off) which is
      the configuration at power-up. This threshold must be calculated
      from a temperature T in Celsius using the formula
      temperature-hi-threshold = 63 + T/0.64 C.


  temperature-lo-threshold:
    type: int
    default: 0
    description: |
      LOW temperature threshold below which an alarm is triggered.
      Valid range is 0 to 255. It defaults to 0 (alarm off) which is
      the configuration at power-up. This threshold must be calculated
      from a temperature T in Celsius using the formula
      temperature-lo-threshold = 63 + T/0.64 C.

  sampling-rate:
    type: int
    default: 0x0
    description: |
      Specify the default output data rate expressed in samples per second (Hz).
      The values are taken in accordance to stts22h_odr_temp_t enumerative in hal/st
      module. Default 0x0 (power down) matches the power-up configuration.

      - 0x00 # STTS22H_POWER_DOWN
      - 0x01 # STTS22H_ONE_SHOT
      - 0x04 # STTS22H_1Hz
      - 0x02 # STTS22H_25Hz
      - 0x12 # STTS22H_50Hz
      - 0x22 # STTS22H_100Hz
      - 0x32 # STTS22H_200Hz

    enum: [0x00, 0x01, 0x02, 0x04, 0x12, 0x22, 0x32]