/*
 * Copyright (c) 2017 Intel Corporation
 *
 * SPDX-License-Identifier: Apache-2.0
 */

#define DT_DRV_COMPAT espressif_esp32_trng

#include <string.h>
#include <soc/rtc.h>
#include <soc/wdev_reg.h>
#include <esp_system.h>
#include <soc.h>
#include <esp_cpu.h>
#include <zephyr/logging/log.h>
#include <zephyr/drivers/entropy.h>
#include <zephyr/drivers/clock_control.h>

LOG_MODULE_REGISTER(entropy, CONFIG_ENTROPY_LOG_LEVEL);

#if SOC_LP_TIMER_SUPPORTED
#include "hal/lp_timer_hal.h"
#endif

#if defined CONFIG_SOC_SERIES_ESP32S3
/* If APB clock is 80 MHz, the maximum sampling frequency is around 45 KHz */
/* 45 KHz reading frequency is the maximum we have tested so far on S3 */
#define APB_CYCLE_WAIT_NUM (1778)
#elif defined CONFIG_SOC_SERIES_ESP32C6
/* On ESP32C6, we only read one byte at a time, then XOR the value with
 * an asynchronous timer (see code below).
 * The current value translates to a sampling frequency of around 62.5 KHz
 * for reading 8 bit samples, which is the rate at which the RNG was tested,
 * plus additional overhead for the calculation, making it slower.
 */
#define APB_CYCLE_WAIT_NUM (160 * 16)
#elif defined CONFIG_SOC_SERIES_ESP32H2
/* Same reasoning as for ESP32C6, but the CPU frequency on ESP32H2 is 96MHz instead of 160 MHz */
#define APB_CYCLE_WAIT_NUM (96 * 16)
#else
#define APB_CYCLE_WAIT_NUM (16)
#endif

static inline uint32_t entropy_esp32_get_u32(void)
{
	/* The PRNG which implements WDEV_RANDOM register gets 2 bits
	 * of extra entropy from a hardware randomness source every APB clock cycle
	 * (provided WiFi or BT are enabled). To make sure entropy is not drained
	 * faster than it is added, this function needs to wait for at least 16 APB
	 * clock cycles after reading previous word. This implementation may actually
	 * wait a bit longer due to extra time spent in arithmetic and branch statements.
	 */

	uint32_t cpu_to_apb_freq_ratio = esp_clk_cpu_freq() / esp_clk_apb_freq();

	static uint32_t last_ccount;
	uint32_t ccount;
	uint32_t result = 0;
#if SOC_LP_TIMER_SUPPORTED
	for (size_t i = 0; i < sizeof(result); i++) {
		do {
			ccount = esp_cpu_get_cycle_count();
			result ^= REG_READ(WDEV_RND_REG);
		} while (ccount - last_ccount < cpu_to_apb_freq_ratio * APB_CYCLE_WAIT_NUM);
		uint32_t current_rtc_timer_counter = (lp_timer_hal_get_cycle_count() & 0xFF);

		result ^= ((result ^ current_rtc_timer_counter) & 0xFF) << (i * 8);
	}
#else
	do {
		ccount = esp_cpu_get_cycle_count();
		result ^= REG_READ(WDEV_RND_REG);
	} while (ccount - last_ccount < cpu_to_apb_freq_ratio * APB_CYCLE_WAIT_NUM);
#endif
	last_ccount = ccount;
	return result ^ REG_READ(WDEV_RND_REG);
}

static int entropy_esp32_get_entropy(const struct device *dev, uint8_t *buf,
				     uint16_t len)
{
	assert(buf != NULL);
	uint8_t *buf_bytes = buf;

	while (len > 0) {
		uint32_t word = entropy_esp32_get_u32();
		uint32_t to_copy = MIN(sizeof(word), len);

		memcpy(buf_bytes, &word, to_copy);
		buf_bytes += to_copy;
		len -= to_copy;
	}

	return 0;
}

static int entropy_esp32_init(const struct device *dev)
{
	const struct device *clock_dev = DEVICE_DT_GET(DT_CLOCKS_CTLR(DT_NODELABEL(trng0)));
	clock_control_subsys_t clock_subsys =
		(clock_control_subsys_t)DT_CLOCKS_CELL(DT_NODELABEL(trng0), offset);

	if (!device_is_ready(clock_dev)) {
		return -ENODEV;
	}

	clock_control_on(clock_dev, clock_subsys);

	return 0;
}

static DEVICE_API(entropy, entropy_esp32_api_funcs) = {
	.get_entropy = entropy_esp32_get_entropy
};

DEVICE_DT_INST_DEFINE(0,
		    entropy_esp32_init, NULL, NULL, NULL,
		    PRE_KERNEL_1, CONFIG_ENTROPY_INIT_PRIORITY,
		    &entropy_esp32_api_funcs);