# Kconfig - Clock controller driver configuration options

#
# Copyright (c) 2015 Intel Corporation
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#     http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#

#
# Clock controller drivers
#
menuconfig CLOCK_CONTROL
	bool
	prompt "Hardware clock controller support"
	default n
	help
	  Enable support for hardware clock controller. Such hardware can
	  provide clock for other subsystem, and thus can be also used for
	  power efficiency by controlling their clock. Note that this has
	  nothing to do with RTC.

if CLOCK_CONTROL

config SYS_LOG_CLOCK_CONTROL_LEVEL
	int
	prompt "Hardware clock controller drivers log level"
	depends on CLOCK_CONTROL
	default 0
	help
	Sets log level for clock controller drivers

	Levels are:

	- 0 OFF, do not write

	- 1 ERROR, only write SYS_LOG_ERR

	- 2 WARNING, write SYS_LOG_WRN in adition to previous level

	- 3 INFO, write SYS_LOG_INF in adition to previous levels

	- 4 DEBUG, write SYS_LOG_DBG in adition to previous levels

source "drivers/clock_control/Kconfig.quark_se"

source "drivers/clock_control/Kconfig.stm32f10x"

endif # CLOCK_CONTROL