# Nordic Semiconductor nRF52 MCU line

# Copyright (c) 2016-2019 Nordic Semiconductor ASA
# SPDX-License-Identifier: Apache-2.0

if SOC_SERIES_NRF52X

config SOC_NRF52805
	bool

config SOC_NRF52810
	bool

config SOC_NRF52811
	bool

config SOC_NRF52820
	bool

config SOC_NRF52832
	bool
	select CPU_CORTEX_M_HAS_DWT
	select CPU_HAS_FPU

config SOC_NRF52833
	bool
	select SOC_COMPATIBLE_NRF52833
	select CPU_CORTEX_M_HAS_DWT
	select CPU_HAS_FPU

config SOC_NRF52840
	bool
	select CPU_CORTEX_M_HAS_DWT
	select CPU_HAS_FPU

choice
	prompt "nRF52x MCU Selection"

config SOC_NRF52805_CAAA
	bool "NRF52805_CAAA"
	select SOC_NRF52805

config SOC_NRF52810_QFAA
	bool "NRF52810_QFAA"
	select SOC_NRF52810

config SOC_NRF52811_QFAA
	bool "NRF52811_QFAA"
	select SOC_NRF52811

config SOC_NRF52820_QDAA
	bool "NRF52820_QDAA"
	select SOC_NRF52820

config SOC_NRF52832_CIAA
	bool "NRF52832_CIAA"
	select SOC_NRF52832

config SOC_NRF52832_QFAA
	bool "NRF52832_QFAA"
	select SOC_NRF52832

config SOC_NRF52832_QFAB
	bool "NRF52832_QFAB"
	select SOC_NRF52832

config SOC_NRF52833_QIAA
	bool "NRF52833_QIAA"
	select SOC_NRF52833

config SOC_NRF52840_QIAA
	bool "NRF52840_QIAA"
	select SOC_NRF52840

endchoice

config SOC_DCDC_NRF52X
	bool
	help
	  Enable nRF52 series System on Chip DC/DC converter.

config SOC_DCDC_NRF52X_HV
	bool
	depends on SOC_NRF52840
	help
	  Enable nRF52 series System on Chip High Voltage DC/DC converter.

config GPIO_AS_PINRESET
	bool "GPIO as pin reset (reset button)"
	default y

config NRF_ENABLE_ICACHE
	bool "The instruction cache (I-Cache)"
	depends on SOC_NRF52832 || SOC_NRF52833 || SOC_NRF52840
	default y

config NRF52_ANOMALY_132_DELAY_US
	int "Anomaly 132 workaround delay (microseconds)"
	default 330
	range 0 330
	depends on NRF52_ANOMALY_132_WORKAROUND
	help
	  Due to Anomaly 132 LF RC source may not start if restarted in certain
	  window after stopping (230 us to 330 us). Software reset also stops the
	  clock so if clock is initiated in certain window, the clock may also fail
	  to start at reboot. A delay is added before starting LF clock to ensure
	  that anomaly conditions are not met. Delay should be long enough to ensure
	  that clock is started later than 330 us after reset. If crystal oscillator
	  (XO) is used then low frequency clock initially starts with RC and then
	  seamlessly switches to XO which has much longer startup time thus,
	  depending on application, workaround may also need to be applied.
	  Additional drivers initialization increases initialization time and delay
	  may be shortened. Workaround is disabled by setting delay to 0.

config NRF52_ANOMALY_198_WORKAROUND
	bool "Anomaly 198 workaround"
	default y
	depends on SOC_NRF52840
	depends on NRFX_SPIM3
	help
	  This anomaly applies to IC revisions "Engineering B" up to "3", the most
	  recent one.

endif # SOC_SERIES_NRF52X