# Copyright (c) 2021 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

properties:
    irq-gpios:
      type: phandle-array
      required: false
      description: |
        DRDY pin

        This pin defaults to active high when produced by the sensor.
        The property value should ensure the flags properly describe
        the signal that is presented to the driver.

    range:
      type: int
      required: false
      default: 2
      description: |
        Range in g. Default is power-up configuration.

      enum:
        - 16 # 16g (0.488 mg/LSB)
        -  8 #  8g (0.244 mg/LSB)
        -  4 #  4g (0.122 mg/LSB)
        -  2 #  2g (0.061 mg/LSB)

    power-mode:
      type: int
      required: false
      default: 0
      description: |
        Specify the sensor power mode. Default is power-down mode

      enum:
        - 0 # Power Down (PD)
        - 1 # Low Power (LP)
        - 2 # High Resolution (HR)
        - 3 # High Frequency (HF)

    odr:
      type: int
      required: false
      default: 0
      description: |
          Specify the default output data rate expressed in samples per second (Hz).
          Default is power-down mode
      enum:
        - 0  # Power-Down
        - 1  # 1Hz (available in LP mode only)
        - 2  # 12.5Hz (available in LP and HR mode)
        - 3  # 25Hz (available in LP and HR mode)
        - 4  # 50Hz (available in LP and HR mode)
        - 5  # 100Hz (available in LP and HR mode)
        - 6  # 200Hz (available in LP and HR mode)
        - 7  # 400Hz (available in LP and HR mode)
        - 8  # 800Hz (available in LP and HR mode)
        - 9  # 1600Hz (available in HF mode only)
        - 10  # 3200Hz (available in HF mode only)
        - 11  # 6400Hz (available in HF mode only)