# SPDX-License-Identifier: Apache-2.0

CONFIG_ARM=y
CONFIG_SOC_SERIES_STM32L4X=y
CONFIG_SOC_STM32L4R5XX=y
CONFIG_BOARD_NUCLEO_L4R5ZI=y

# 120MHz system clock only in 'boost power' mode. DM00310109, section
# 5.1.7 states that the R1MODE bit must be cleared before system can
# be 120MHz. This requires an update to the stm32 clock control
# driver, so default to 80MHz until then.
# CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=120000000

# 80MHz system clock in 'normal power' mode
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=80000000

# enable uart driver
CONFIG_SERIAL=y

# enable pinmux
CONFIG_PINMUX=y

# Enable GPIO
CONFIG_GPIO=y

# Clock Configuration
CONFIG_CLOCK_CONTROL=y

# Use PLLCLK for SYSCLK
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y

# Use HSI (16MHz) to feed into PLL
CONFIG_CLOCK_STM32_PLL_SRC_HSI=y

CONFIG_CLOCK_STM32_PLL_M_DIVISOR=4
CONFIG_CLOCK_STM32_PLL_P_DIVISOR=7
CONFIG_CLOCK_STM32_PLL_Q_DIVISOR=2
CONFIG_CLOCK_STM32_PLL_R_DIVISOR=2

# Produce 80MHz clock at PLLCLK output
CONFIG_CLOCK_STM32_PLL_N_MULTIPLIER=40

# Comment out above and uncomment below for 120MHz. Note that you
# must have configured the mcu for boost power mode.
# CONFIG_CLOCK_STM32_PLL_N_MULTIPLIER=60

# Produce Max (80MHz or 120MHz) HCLK
CONFIG_CLOCK_STM32_AHB_PRESCALER=1

# Produce Max (80MHz or 120MHz) APB1 clocks and APB2 clocks
CONFIG_CLOCK_STM32_APB1_PRESCALER=1
CONFIG_CLOCK_STM32_APB2_PRESCALER=1

# Console
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y

# Enable MPU
CONFIG_ARM_MPU=y