CONFIG_BT=y
CONFIG_BT_CENTRAL=y
CONFIG_BT_PERIPHERAL=y
CONFIG_BT_DEVICE_NAME="L2CAP stress test"

CONFIG_BT_EATT=n
CONFIG_BT_L2CAP_ECRED=n

CONFIG_BT_SMP=y # Next config depends on it
CONFIG_BT_L2CAP_DYNAMIC_CHANNEL=y

# Disable auto-initiated procedures so they don't
# mess with the test's execution.
CONFIG_BT_AUTO_PHY_UPDATE=n
CONFIG_BT_AUTO_DATA_LEN_UPDATE=n
CONFIG_BT_GAP_AUTO_UPDATE_CONN_PARAMS=n

# L2CAP MPS
# 23+27+27=77 makes exactly three full packets
CONFIG_BT_L2CAP_TX_MTU=77

# Use this to send L2CAP PDUs without any fragmentation.
# In this particular case, we prefer fragmenting to test that code path.
# CONFIG_BT_BUF_ACL_TX_SIZE=81

# L2CAP PDUs will be fragmented in 3 ACL packets.
CONFIG_BT_BUF_ACL_TX_SIZE=27

CONFIG_BT_BUF_ACL_TX_COUNT=4

# The minimum value for this is
# L2AP MPS + L2CAP header (4)
CONFIG_BT_BUF_ACL_RX_SIZE=81

# Governs BT_CONN_TX_MAX, and so must be >= than the max number of
# peers, since we attempt to send one SDU per peer. The test execution
# is a bit slowed down by having this at the very minimum, but we want
# to keep it that way as to stress the stack as much as possible.
CONFIG_BT_L2CAP_TX_BUF_COUNT=6

CONFIG_BT_CTLR_DATA_LENGTH_MAX=27
CONFIG_BT_CTLR_RX_BUFFERS=10

CONFIG_BT_MAX_CONN=10

CONFIG_LOG=y
CONFIG_ASSERT=y
CONFIG_NET_BUF_POOL_USAGE=y

# CONFIG_BT_L2CAP_LOG_LEVEL_DBG=y
# CONFIG_BT_CONN_LOG_LEVEL_DBG=y
CONFIG_LOG_THREAD_ID_PREFIX=y
CONFIG_THREAD_NAME=y

CONFIG_ARCH_POSIX_TRAP_ON_FATAL=y