# Kconfig - STM32 I2S driver configuration options
#
# Copyright (c) 2018 STMicroelectronics
#
# SPDX-License-Identifier: Apache-2.0
#

menuconfig I2S_STM32
	bool "STM32 MCU I2S controller driver"
	depends on I2S && SOC_SERIES_STM32F4X
	select DMA
	help
	  Enable I2S support on the STM32 family of processors.
	  (Tested on the STM32F4 series)

if I2S_STM32

config I2S_STM32_RX_BLOCK_COUNT
	int "RX queue length"
	default 4

config I2S_STM32_TX_BLOCK_COUNT
	int "TX queue length"
	default 4

config I2S_STM32_USE_PLLI2S_ENABLE
	bool "Enable usage of PLL"
	help
	  Enable it if I2S clock should be provided by the PLLI2S.
	  If not enabled the clock will be provided by HSI/HSE.

config I2S_STM32_PLLI2S_PLLM
	int "Division factor for PLLI2S VCO input clock"
	depends on I2S_STM32_USE_PLLI2S_ENABLE
	default 8
	range 2 63
	help
	  Division factor for the audio PLL (PLLI2S) VCO input clock.
	  PLLM factor should be selected to ensure that the VCO
	  input frequency ranges from 1 to 2 MHz. It is recommended
	  to select a frequency of 2 MHz to limit PLL jitter.
	  Allowed values: 2-63

config I2S_STM32_PLLI2S_PLLN
	int "Multiplier factor for PLLI2S VCO output clock"
	depends on I2S_STM32_USE_PLLI2S_ENABLE
	default 56
	range 50 432
	help
	  Multiply factor for the audio PLL (PLLI2S) VCO output clock.
	  PLLN factor should be selected to ensure that the VCO
	  output frequency ranges from 100 to 432 MHz.
	  Allowed values: 50-432

config I2S_STM32_PLLI2S_PLLR
	int "Division factor for I2S clock"
	depends on I2S_STM32_USE_PLLI2S_ENABLE
	default 7
	range 2 7
	help
	  Division factor for the I2S clock.
	  PLLR factor should be selected to ensure that the I2S clock
	  frequency is less than or equal to 192MHz.
	  Allowed values: 2-7

config I2S_1
	bool "I2S port 1"
	help
	  Enable I2S controller port 1.

config I2S_2
	bool "I2S port 2"
	help
	  Enable I2S controller port 2.

config I2S_3
	bool "I2S port 3"
	help
	  Enable I2S controller port 3.

config I2S_4
	bool "I2S port 4"
	help
	  Enable I2S controller port 4.

config I2S_5
	bool "I2S port 5"
	help
	  Enable I2S controller port 5.

endif # I2S_STM32