.. _st7789v_generic:

Generic ST7789V Display Shield
##############################

Overview
********

This is a generic shield for display shields based on ST7789V display
controller. More information about the controller can be found in
`ST7789V Datasheet`_.

Pins Assignment of the Generic ST7789V Display Shield
=====================================================

+-----------------------+--------------------------------------------+
| Arduino Connector Pin | Function                                   |
+=======================+===============+============================+
| D8                    | ST7789V Reset |                            |
+-----------------------+---------------+----------------------------+
| D9                    | ST7789V DC    | (Data/Command)             |
+-----------------------+---------------+----------------------------+
| D10                   | SPI SS        | (Serial Slave Select)      |
+-----------------------+---------------+----------------------------+
| D11                   | SPI MOSI      | (Serial Data Input)        |
+-----------------------+---------------+----------------------------+
| D12                   | SPI MISO      | (Serial Data Out)          |
+-----------------------+---------------+----------------------------+
| D13                   | SPI SCK       | (Serial Clock Input)       |
+-----------------------+---------------+----------------------------+

Current supported displays
==========================

+----------------------+------------------------------+
| Display              | Shield Designation           |
|                      |                              |
+======================+==============================+
| TL019FQV01           | st7789v_tl019fqv01           |
|                      |                              |
+----------------------+------------------------------+
| Waveshare 240x240    | st7789v_waveshare_240x240    |
| 1.3inch IPS LCD      |                              |
+----------------------+------------------------------+

Requirements
************

This shield can only be used with a board that provides a configuration
for Arduino connectors and defines node aliases for SPI and GPIO interfaces
(see :ref:`shields` for more details).

Programming
***********

Set ``-DSHIELD=st7789v_tl019fqv01`` when you invoke ``west build``. For example:

.. zephyr-app-commands::
   :zephyr-app: samples/subsys/display/lvgl
   :board: nrf52840dk_nrf52840
   :shield: st7789v_tl019fqv01
   :goals: build

References
**********

.. target-notes::

.. _ST7789V Datasheet:
   https://www.newhavendisplay.com/appnotes/datasheets/LCDs/ST7789V.pdf