#CONFIG_INIT_STACKS=y      # if set, lots of noise from mesh/adv.c: STACK_ANALYZE
CONFIG_MAIN_STACK_SIZE=512
CONFIG_SYSTEM_WORKQUEUE_STACK_SIZE=2048

CONFIG_GPIO=y

CONFIG_BT_SETTINGS=y
CONFIG_FLASH=y
CONFIG_FLASH_PAGE_LAYOUT=y
CONFIG_FLASH_MAP=y
CONFIG_NVS=y
CONFIG_SETTINGS=y
CONFIG_BT_MESH_RPL_STORE_TIMEOUT=600

CONFIG_BOOT_BANNER=y

CONFIG_BT_OBSERVER=y
CONFIG_BT_BROADCASTER=y
CONFIG_BT_CTLR_DUP_FILTER_LEN=0
CONFIG_BT_CTLR_LE_ENC=n
CONFIG_BT_CTLR_LE_PING=n
CONFIG_BT_DATA_LEN_UPDATE=n
CONFIG_BT_PHY_UPDATE=n
CONFIG_BT_CTLR_CHAN_SEL_2=n
CONFIG_BT_CTLR_MIN_USED_CHAN=n
CONFIG_BT_CTLR_ADV_EXT=n
CONFIG_BT_CTLR_PRIVACY=n

CONFIG_BT_PERIPHERAL=y

CONFIG_BT=y
CONFIG_BT_TINYCRYPT_ECC=y
CONFIG_BT_L2CAP_TX_BUF_COUNT=8

CONFIG_BT_MESH=y
CONFIG_BT_MESH_RELAY=y
CONFIG_BT_MESH_RELAY_ENABLED=n
CONFIG_BT_MESH_BEACON_ENABLED=n
CONFIG_BT_MESH_LOW_POWER=n
CONFIG_BT_MESH_FRIEND=n
CONFIG_BT_MESH_FRIEND_QUEUE_SIZE=16
CONFIG_BT_MESH_ADV_BUF_COUNT=20
CONFIG_BT_MESH_TX_SEG_MAX=6

CONFIG_BT_MESH_PB_GATT=y
CONFIG_BT_MESH_PB_ADV=y
CONFIG_BT_MESH_GATT_PROXY=y
CONFIG_BT_MESH_CFG_CLI=y

#CONFIG_BT_MESH_LPN_SCAN_LATENCY=30
#CONFIG_BT_MESH_LPN_RECV_DELAY=40
#CONFIG_BT_MESH_LPN_POLL_TIMEOUT=300

CONFIG_BT_MESH_SUBNET_COUNT=2
CONFIG_BT_MESH_APP_KEY_COUNT=2
CONFIG_BT_MESH_MODEL_KEY_COUNT=2
CONFIG_BT_MESH_MODEL_GROUP_COUNT=2
CONFIG_BT_MESH_LABEL_COUNT=3

#CONFIG_BT_MESH_IV_UPDATE_TEST=y

CONFIG_UART_CONSOLE=y

# this outputs btmon formatted data to the serial port
#CONFIG_BT_DEBUG_MONITOR_UART=y

CONFIG_BT_DEBUG_LOG=y

CONFIG_BT_MESH_DEBUG=y
#CONFIG_BT_MESH_DEBUG_PROV=y
#CONFIG_BT_MESH_DEBUG_PROXY=y
#CONFIG_BT_MESH_DEBUG_BEACON=y
#CONFIG_BT_MESH_DEBUG_NET=y
#CONFIG_BT_MESH_DEBUG_TRANS=y
#CONFIG_BT_MESH_DEBUG_LOW_POWER=y
#CONFIG_BT_MESH_DEBUG_FRIEND=y
#CONFIG_BT_MESH_DEBUG_MODEL=y
#CONFIG_BT_MESH_DEBUG_ACCESS=y
#CONFIG_BT_MESH_DEBUG_CRYPTO=y
#CONFIG_BT_MESH_DEBUG_ADV=y
#CONFIG_BT_MESH_SELF_TEST=y

#CONFIG_BT_HCI_VS_EXT=n

#CONFIG_STACK_USAGE=y

CONFIG_BT_RX_STACK_SIZE=4096

#CONFIG_BT_DEBUG_HCI_DRIVER=y
#CONFIG_BT_DEBUG_HCI_CORE=y
#CONFIG_BT_DEBUG_GATT=y
#CONFIG_BT_DEBUG_CONN=y

CONFIG_BT_MAX_CONN=1
CONFIG_BT_CTLR_RX_BUFFERS=6
CONFIG_BT_BUF_ACL_TX_COUNT=4
CONFIG_BT_BUF_CMD_TX_COUNT=4

CONFIG_BT_ATT_PREPARE_COUNT=2

#CONFIG_NET_BUF_SIMPLE_LOG=y
#CONFIG_NET_BUF_LOG=y
#CONFIG_BT_CTLR_DEBUG_PINS=y