/*
 * Copyright (c) 2019 Linaro Limited
 *
 * SPDX-License-Identifier: Apache-2.0
 */

/**
 * @file
 * @brief System/hardware module for STM32H7 CM4 processor
 */

#include <zephyr/kernel.h>
#include <zephyr/device.h>
#include <zephyr/init.h>
#include <zephyr/irq.h>
#include <soc.h>
#include <stm32_ll_bus.h>
#include <stm32_ll_cortex.h>
#include <stm32_ll_pwr.h>
#include <stm32_ll_rcc.h>
#include <stm32_ll_system.h>
#include <zephyr/arch/cpu.h>
#include <zephyr/arch/arm/aarch32/cortex_m/cmsis.h>
#include <zephyr/arch/arm/aarch32/nmi.h>
#include "stm32_hsem.h"

/**
 * @brief Perform basic hardware initialization at boot.
 *
 * This needs to be run from the very beginning.
 * So the init priority has to be 0 (zero).
 *
 * @return 0
 */
static int stm32h7_m4_init(const struct device *arg)
{
	uint32_t key;

	/* Enable ART Flash cache accelerator */
	LL_AHB1_GRP1_EnableClock(LL_AHB1_GRP1_PERIPH_ART);
	LL_ART_SetBaseAddress(DT_REG_ADDR(DT_CHOSEN(zephyr_flash)));
	LL_ART_Enable();

	key = irq_lock();

	/* Install default handler that simply resets the CPU
	 * if configured in the kernel, NOP otherwise
	 */
	NMI_INIT();

	irq_unlock(key);

	/* In case CM4 has not been forced boot by CM7,
	 * CM4 needs to wait until CM7 has setup clock configuration
	 */
	if (!LL_RCC_IsCM4BootForced()) {
		/*
		 * Domain D2 is waiting for Cortex-M7 to perform
		 * system initialization
		 * (system clock config, external memory configuration.. ).
		 * End of system initialization is reached when CM7 takes HSEM.
		 */
		LL_AHB4_GRP1_EnableClock(LL_AHB4_GRP1_PERIPH_HSEM);
		while ((HSEM->RLR[CFG_HW_ENTRY_STOP_MODE_SEMID] & HSEM_R_LOCK)
				!= HSEM_R_LOCK)
			;
	}

	return 0;
}

SYS_INIT(stm32h7_m4_init, PRE_KERNEL_1, 0);