#
# Copyright (c) 2020 Linumiz
#
# SPDX-License-Identifier: Apache-2.0
#

description: Texas Instruments BQ274xx Fuel Gauge

compatible: "ti,bq274xx"

include: [sensor-device.yaml, i2c-device.yaml]

properties:
  design-voltage:
    type: int
    required: true
    description: Battery Design Voltage in mV (3300 - 4400)

  design-capacity:
    type: int
    required: true
    description: Battery Design Capacity in mAh

  taper-current:
    type: int
    required: true
    description: Battery Taper current in mAh

  terminate-voltage:
    type: int
    required: true
    description: Battery Terminate Voltage in mV

  int-gpios:
    type: phandle-array
    description: |
      The INT signal defaults to active low open drain, so requires a
      pull-up on the board. By default it acts as an output and signals
      specific events happening (e.g. change in State of Charge).
      Note this pin is required for this sensor's power management APIs: in
      shutdown mode it acts as an input and toggling it will make the sensor
      exit the mode.

  zephyr,lazy-load:
    type: boolean
    description: |
      Configuring the sensor can take a long time, using lazy loading we can delay
      until the first sample request and keep the boot time as short as possible.