---
title: <short description of the node>
version: 0.1

description: >
    Longer free-form description of the node, with spanning
    lines

inherits:
  - !include other.yaml # or [other1.yaml, other2.yaml]
# Files with other bindings that also apply to the node. If an attribute is set
# both in an included file and in the file that includes it, then the value
# from the including file (the file with the !include) is used.

< parent | child >:
# parent/child is used to document implicit relation between nodes.
# This information is required to generate parent related bits in child
# attributes.
# In case parent has 'bus', slave inherits some information from master.
# parent and child should share same bus-type value.
   bus: <bus-type>

properties:

# A typical property entry looks like this:
#
#   <name of the property in the device tree - regexes are supported>:
#     category: <required | optional>
#     type: <string | int | array | compound>
#     description: <description of property>
#     generation: define
#
# The 'generation' attribute can be set to 'define, use-prop-name' to use the
# property name instead of a generic controller name, e.g. *_CS_GPIO_* instead
# of *_GPIOS_*.
#
# The exact value of the 'generation' attribute is ignored otherwise. The
# output is always #define's.
#
# The 'type' attribute is currently ignored.

# At a minimum, an entry for the 'compatible' property is required, for
# matching nodes
    compatible: <list of string compatible matches>
      category: required
      type: string
      description: compatible of node
      generation: define

# 'reg' describes mmio registers
    reg:
      category: required
      type: array
      description: mmio register space
      generation: define

# 'interrupts' specifies the interrupts that the driver may use
    interrupts:
      category: required
      type: array
      description: required interrupts
      generation: define

# If a node is an interrupt controller, GPIO controller, pinmux device, or any
# device referenced via a phandle plus some number of cells, then the cell
# fields below must be present

"#cells":
  - cell0    # name of first cell
  - cell1    # name of second cell
  - cell2    # name of third cell
  - and so on and so forth

...