/*
 * Copyright (c) 2019 Interay Solutions B.V.
 * Copyright (c) 2019 Oane Kingma
 *
 * SPDX-License-Identifier: Apache-2.0
 */

#include <init.h>
#include "board.h"
#include <drivers/gpio.h>
#include <sys/printk.h>
#include "em_cmu.h"

static int efm32gg_stk3701a_init(const struct device *dev)
{
	const struct device *cur_dev;

	ARG_UNUSED(dev);

	/* Enable the board controller to be able to use the serial port */
	cur_dev = device_get_binding(BC_ENABLE_GPIO_NAME);
	if (!cur_dev) {
		printk("Board controller gpio port was not found!\n");
		return -ENODEV;
	}

	gpio_pin_configure(cur_dev, BC_ENABLE_GPIO_PIN, GPIO_OUTPUT);
	gpio_pin_set(cur_dev, BC_ENABLE_GPIO_PIN, 1);

#ifdef CONFIG_ETH_GECKO
	/* Enable the ethernet PHY power */
	cur_dev = device_get_binding(ETH_PWR_ENABLE_GPIO_NAME);
	if (!cur_dev) {
		printk("Ethernet PHY power gpio port was not found!\n");
		return -ENODEV;
	}

	gpio_pin_configure(cur_dev, ETH_PWR_ENABLE_GPIO_PIN, GPIO_OUTPUT);
	gpio_pin_set(cur_dev, ETH_PWR_ENABLE_GPIO_PIN, 1);

	/* Configure ethernet reference clock */
	cur_dev = device_get_binding(ETH_REF_CLK_GPIO_NAME);
	if (!cur_dev) {
		printk("Ethernet reference clock gpio port was not found!\n");
		return -ENODEV;
	}

	gpio_pin_configure(cur_dev, ETH_REF_CLK_GPIO_PIN, GPIO_OUTPUT);
	gpio_pin_set(cur_dev, ETH_REF_CLK_GPIO_PIN, 0);

	/* enable CMU_CLK2 as RMII reference clock */
	CMU->CTRL      |= CMU_CTRL_CLKOUTSEL2_HFXO;
	CMU->ROUTELOC0 = (CMU->ROUTELOC0 & ~_CMU_ROUTELOC0_CLKOUT2LOC_MASK) |
		(ETH_REF_CLK_LOCATION << _CMU_ROUTELOC0_CLKOUT2LOC_SHIFT);
	CMU->ROUTEPEN  |= CMU_ROUTEPEN_CLKOUT2PEN;

	/* Release the ethernet PHY reset */
	cur_dev = device_get_binding(ETH_RESET_GPIO_NAME);
	if (!cur_dev) {
		printk("Ethernet PHY reset gpio port was not found!\n");
		return -ENODEV;
	}

	gpio_pin_configure(cur_dev, ETH_RESET_GPIO_PIN, GPIO_OUTPUT);
	gpio_pin_set(cur_dev, ETH_RESET_GPIO_PIN, 1);
#endif /* CONFIG_ETH_GECKO */

	return 0;
}

/* needs to be done after GPIO driver init */
SYS_INIT(efm32gg_stk3701a_init, PRE_KERNEL_1, CONFIG_BOARD_INIT_PRIORITY);